Monarda ( Beauty of Cobham Monarda )

Characteristics

Cultivar:	Beauty Of Cobham
Family:	Lamiaceae
Size:	Height: 2.5 ft. to 3 ft. Width: 0.83 ft. to 1.5 ft.
Plant Category:	herbs, perennials,
Plant Characteristics:	edible flowers, seed start,
Foliage Characteristics:	fragrant, medium leaves,
Foliage Color:	blue-green to gold, green, red to burgundy,
Flower Characteristics:	fragrant, long lasting, showy,
Flower Color:	pinks, purples,
Tolerances:	deer, pollution, seashore, slope, wind,

Requirements

Bloomtime Range:	Mid Summer to Early Fall
USDA Hardiness Zone:	4 to 9
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Shade to Full Sun
pH Range:	5.5 to 7.5
Soil Range:	Some Sand to Clay Loam
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-tos : Fertilization for Annuals and Perennials

Annuals and perennials may be fertilized using: 1.water-soluble, quick release fertilizers; 2. temperature controlled slow-release fertilizers; or 3. organic fertilizers such as fish emulsion. Water soluble fertilizers are generally used every two weeks during the growing season or per label instructions. Controlled, slow-release fertilizers are worked into the soil ususally only once during the growing season or per label directions. For organic fertilizers such as fish emulsion, follow label directions as they may vary per product.

Light

Conditions : Dappled Light

Dappled Light refers to a dappled pattern of light created on the ground, as cast by light passing through high tree branches. This is the middle ground, not considered shady, but not sunny either. Dappled remains constant throughout the day.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Planting

How-tos : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

How-tos : Pinching and Thinning Perennials

Once you plant a perennial, it does not mean that you will enjoy years of maintenance-free gardening. Perennials need to be cared for just like any other plant. One thing that distinguishes perennials is that they tend to be active growers that have to be thinned out occasionally or they will loose vigor.

As perennials establish, it is important to prune them back and thin them out occasionally. This will prevent them from completely taking over an area to the exclusion of other plants, and also will increase air circulation thereby reducing the incidence of diseases like botrytis and powdery mildew.

Many species also flower abundantly and produce ample seed. As blooms fade it is advisable to deadhead your plant; that is, to remove spent flowers before they form seed. This will prevent your plants from seeding all over the garden and will conserve the considerable energy it takes the plant to produce seed.

As perennials mature, they may form a dense root mass that eventually leads to a less vigorous plant. It is advisable to occasionally thin out a stand of such perennials. By dividing the root system, you can make new plants to plant in another area of the garden or give away. Also root pruning will stimulate new growth and rejuvenate the plant. Most perennials may be successfully divided in either spring or fall. Do a little homework; some perennials do have a preference.

How-tos : Planting Perennials

Determine appropriate perennials for your garden by considering sun and shade through the day, exposure, water requirements, climate, soil makeup, seasonal color desired, and position of other garden plants and trees.

The best times to plant are spring and fall, when soil is workable and out of danger of frost. Fall plantings have the advantage that roots can develop and not have to compete with developing top growth as in the spring. Spring is more desirable for perennials that dislike wet conditions or for colder areas, allowing full establishment before first winter. Planting in summer or winter is not advisable for most plants, unless planting a more established sized plant.

To plant container-grown plants: Prepare planting holes with appropriate depth and space between. Water the plant thoroughly and let the excess water drain before carefully removing from the container. Carefully loosen the root ball and place the plant in the hole, working soil around the roots as you fill. If the plant is extremely root bound, separate roots with fingers. A few slits made with a pocket knife are okay, but should be kept to a minimum. Continue filling in soil and water thoroughly, protecting from direct sun until stable.

To plant bare-root plants: Plant as soon as possible after purchase. Prepare suitable planting holes, spread roots and work soil among roots as you fill in. Water well and protect from direct sun until stable.

To plant seedlings: A number of perennials produce self-sown seedlings that can be transplanted. You may also start your own seedling bed for transplanting. Prepare suitable planting holes, spacing appropriately for plant development. Gently lift the seedling and as much surrounding soil as possible with your garden trowel, and replant it immediately, firming soil with fingertips and water well. Shade from direct sun and water regularly until stable.

Problems

Fungi : Rusts

Most rusts are host specific and overwinter on leaves, stems and spent flower debris. Rust often appears as small, bright orange, yellow, or brown pustules on the underside of leaves. If touched, it will leave a colored spot of spores on the finger. Caused by fungi and spread by splashing water or rain, rust is worse when weather is moist.

Prevention and Control: Plant resistant varieties and provide maximum air circulation. Clean up all debris, especially around plants that have had a problem. Do not water from overhead and water only during the day so that plants will have enough time to dry before night. Apply a fungicide labeled for rust on your plant.

Fungi : Powdery Mildew

Powdery Mildew is usually found on plants that do not have enough air circulation or adequate light. Problems are worse where nights are cool and days are warm and humid. The powdery white or gray fungus is usually found on the upper surface of leaves or fruit. Leaves will often turn yellow or brown, curl up, and drop off. New foliage emerges crinkled and distorted. Fruit will be dwarfed and often drops early.

Prevention and Control: Plant resistant varieties and space plants properly so they receive adequate light and air circulation. Always water from below, keeping water off the foliage. This is paramount for roses. Go easy on the nitrogen fertilizer. Apply fungicides according to label directions before problem becomes severe and follow directions exactly, not missing any required treatments. Sanitation is a must - clean up and remove all leaves, flowers, or debris in the fall and destroy.

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.

Miscellaneous

Conditions : Deer Tolerant

There are no plants that are 100% deer resistant, but many that are deer tolerant. There are plants that deer prefer over others. You will find that what deer will or will not eat varies in different parts of the country. A lot of it has to do with how hungry they are. Most deer will sample everything at least once, decide if they like it or not and return if favorable. A fence is the good deer barrier. You may go for a really tall one (7 to 8 feet), or try 2 parallel fences, (4 to 5 feet apart). Use a wire mesh fence rather than board, since deer are capable of wiggling through a 12 inch space.

Conditions : Pollution Tolerant

Air pollution is becoming a bigger problem each day. Pollutants in our air damage plants. The plants are damaged by absorbing sulfur dioxide, ozone, peroxyacetyl nitrate, ethylene, and nitrogen dioxide through their pores. Cell membrane damage may result in leaf drop, blotched or burnt looking leaves, or off-colored tissue between veins. Vehicles and industrial processes are the key culprits and conditions worsen on hot summer days. Though planting only pollution tolerant plants is not the solution to this problem, it is a visual bandaid. Your Cooperative Extension Service may have a list of plants that are more pollution tolerant in your area.

Conditions : Salt Tolerant

Anyone that lives close to the coast or in areas where soil salt content is high, can appreciate a plant that is salt tolerant. Salt damage is usually worse where the climate is arid: there is not enough rainfall to wash built up salts from the soil. It takes about 30 inches of rainfall a year to move salt through the soil. Plants that have salt damage usually have yellow leaves, brown tips or margins, and leaf drop. Soils may have a crusty white layer, too. Salt tolerant plants are often natives or introduced plants that have evolved in salty conditions.

Conditions : Slope Tolerant

Slope tolerant plants are those that have a fibrous root system and are often plants that prefer good soil drainage. These plants assist in erosion control by stabilizing/holding the soil on slopes intact.

Conditions : Wind Tolerant

Plants that are wind tolerant usually have flexible, strong branches that are not brittle. Wind tolerant plants often have thick or waxy leaves that control moisture loss from whipping winds. Native plants are often the best adapted to not only wind, but also soil and other climatic conditions.

Edibles : Edible Flowers

Some flowers are edible or have edible portions that are not only beautiful, but nutritious and tasty. Buds, flowers, leaves, stems, and roots are selected from designated edible varieties. Plant as you would a regular flower, but use only organic practices. If you are not a total organic gardener, separate growing areas should be used for the growing of edible flowers.

When portions of edible flowers are desired, pull petals or edible portions from fresh flowers and snip off the petals from the base of the flower. Remember to always wash flowers thoroughly making certain any residue or dirt has been removed. Give them a gentle bath in water and then dip the petals in ice water to perk them up. Drain on paper towels. Petals and whole flowers may be stored for a short time in plastic bags in refrigeration. Freeze whole small flowers in ice rings or cubes. Make sure you know what the flower is before you eat it; have an accurate identification done.

Glossary : Bird Attracting

The term bird attracting applies to any plant that has flowers, fruit, nuts, or structure that attracts birds. Most plants on ""bird attracting"" lists have favorable fruits or flowers that serve as food, but the trunks, limbs and foliage cover that trees and shrubs provide should not be overlooked as they add shelter for raising young and protection from foul weather.

Glossary : Border Plant

A border plant is one which looks especially nice when used next to other plants in a border. Borders are different from hedges in that they are not clipped. Borders are loose and billowy, often dotted with deciduous flowering shrubs. For best effect, mass smaller plants in groups of 3, 5, 7, or 9. Larger plants may stand alone, or if room permits, group several layers of plants for a dramatic impact. Borders are nice because they define property lines and can screen out bad views and offer seasonal color. Many gardeners use the border to add year round color and interest to the garden.

Glossary : Herbaceous

Herbaceous refers to a non-woody plant that dies back at the end of its growing season, generally after frost or during the fall of the year. The rootstock of perennials will overwinter, providing the plant is hardy in that area, and resume growth in the spring.

Glossary : Perennial

Perennial: traditionally a non-woody plant that lives for two or more growing seasons.

Glossary : U. S. Natives

Native plants require lower maintenance and usually have less pest problems. They are key components in the xeriphytic landscape and backyard wildlife habitat. Select your region and the search will look for all plants in the database that are native to your area.