An upright, rounded tree with toothed, green leaves. Flowers in spring, in alternate years. Single, cupped pinkish to white flowers. Cherry-like yellow fruit. Requires moist, well-drained soil. Prefers full sun, but tolerates partial shade.
Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.
Conditions : Partial Shade
Partial Shade is defined as filtered light found beneath trees with high limbs. Partial shade usually offers some protection from direct afternoon sun.
Conditions : Partial Sun, Partial Shade
Part sun or part shade plants prefer light that is filtered. Sunlight, though not direct, is important to them. Often morning sun, because it is
not as strong as afternoon sun, can be considered part sun or part shade. If you live in an area that does not get much intense sun, such as the Pacific Northwest, a full sun exposure may be fine. In other areas such as Florida,
plant in a location where afternoon shade will be received.
Conditions : Types of Pruning
Types of pruning include: pinching, thinning, shearing and rejuvenating.
Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.
Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.
Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.
Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.
Conditions : Full Sun
Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.
How-to : Xeriscaping
Xeriscaping is a method of planting which promotes naturally drought tolerant plants and water saving methods. Much consideration is given not only to the plants chosen for the design, but the design itself. Lawns are greatly decreased in size and usually located in the center of plantings at a lower grade as to catch any runoff. Shrubs requiring the most water, are conservatively used and thoughtfully placed, where they may be easily watered, preferably from runoff, and moisture conserved. There is a strong emphasis on using native plants, which a purist will do exclusively. At the very least, improved cultivars of natives are highly recommended.
Irrigation maybe used to supplement watering, but takes a creative turn in the form of drip systems and recycled catch water. Organic mulches in the form of compost, straws, and barks are also used to retain as much water as possible. In extremely dry areas, it is not uncommon for gravel and rocks to serve as the mulch.
A xeriphytic landscape is one that takes your particular site into consideration. A plant that maybe considered low water usage in one area of the country, may not be in another area, due to climatic stresses.
Conditions : Moist and Well Drained
Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.
Conditions : Outdoor Watering
Plants are almost completely made up of water so it is important to supply them
with adequate water to maintain good plant health. Not enough water and roots
will wither and the plant will wilt and die. Too much water applied too
frequently deprives roots of oxygen leading to plant diseases such as root and
stem rots. The type of plant, plant age, light level, soil type and container
size all will impact when a plant needs to be watered. Follow these tips to
ensure successful watering:
* The key to watering is water deeply and less frequently. When watering, water
well, i.e. provide enough water to thoroughly saturate the root ball. With
in-ground plants, this means thoroughly soaking the soil until water has
penetrated to a depth of 6 to 7 inches (1' being better). With container grown plants, apply enough water to allow water to flow through the drainage holes.
* Try to water plants early in the day or later in the afternoon to conserve
water and cut down on plant stress. Do water early enough so that water has
had a chance to dry from plant leaves prior to night fall. This is paramount
if you have had fungus problems.
* Don't wait to water until plants wilt. Although some plants will recover from this,
all plants will die if they wilt too much (when they reach the permanent
* Consider water conservation methods such as drip irrigation, mulching, and
xeriscaping. Drip systems which slowly drip moisture directly on the root
system can be purchased at your local home and garden center. Mulches can significantly cool the root zone
and conserve moisture.
* Consider adding water-saving gels to the root zone which will hold a reserve
of water for the plant. These can make a world of difference especially under
stressful conditions. Be certain to follow label directions for their use.
Conditions : Normal Watering for Outdoor Plants
Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.
How-to : Pruning Trees After Planting
It is critical to prune trees correctly from the beginning to assure proper growth and development. Young trees can be transplanted in a number of forms: bare root, balled & burlap and in containers. The more stress the plant undergoes in the transplant process, the more pruning that is required to compensate.
Deciduous trees like maples (those that loose their leaves in the fall) can be dug up and sold with their bare roots exposed. Because most of the root system is lost in digging, sufficient top growth should be removed to compensate for this loss. This may be done at the nursery before you buy the plant or you may have to prune at the time of planting. Select and head back the best scaffold branches, i.e. those branches which will form the main lateral structure of the future mature tree. Remove all other extraneous side branches. If the tree seedling does not have branches, allow it to grow to the desired height of branching then pinch it back to stimulate the lower buds to form branches.
Ball and burlap trees are dug up with their root systems somewhat intact. This was mostly done for conifers and broadleaf evergreens, but has become common for deciduous trees as well. Since some root mass is lost in the digging stage, a light pruning is generally called for. Head back the plant to compensate for this loss and to promote branching.
Trees that are grown in containers generally do not loose roots in the transplanting phase. Therefore you do not generally have to prune them unless there is some root injury or limb damage in the planting process.
Once you have your trees planted, be patient. Do not remove shoots from the trunk early on as these allow the tree to grow more rapidly and also shade the tender young trunk from sun-scald. Wait a few years to begin training the tree to its ultimate form.
How-to : Planting a Tree
Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball
and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the
If container-grown, lay the tree on its side and remove the container. Loosen
the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.
If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick
out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in
wire baskets. Plant as you would a b&b plant, but cut as much of the wire away
as possible without actually removing the basket. Chances are, you would do more
damage to the rootball by removing the basket.
Simply cut away wires to leave several large openings for roots.
Fill both holes with soil the same way. Never amend with less than half original soil.
Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.
Create a water ring around the outer edge of the hole. Not only will this
conseve water, but will direct moisture to perimeter roots, encouraging
outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched,
so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled
area. Remove any damaged limbs.
Pest : Aphids
Aphids are small, soft-bodied, slow-moving insects that suck fluids from plants. Aphids come in many colors, ranging from green to brown to black, and they may have wings. They attack a wide range of plant species causing stunting, deformed leaves and buds. They can transmit harmful plant viruses with their piercing/sucking mouthparts. Aphids, generally, are merely a nuisance, since it takes many of them to cause serious plant damage. However aphids do produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface growth called sooty mold.
Aphids can increase quickly in numbers and each female can produce up to 250 live nymphs in the course of a month without mating. Aphids often appear when the environment changes - spring & fall. They're often massed at the tips of branches feeding on succulent tissue. Aphids are attracted to the color yellow and will often hitchhike on yellow clothing.
Prevention and Control: Keep weeds to an absolute minimum, especially around desirable plants. On edibles, wash off infected area of plant. Lady bugs and lacewings will feed on aphids in the garden. There are various products - organic and inorganic - that can be used to control aphids. Seek the recommendation of a professional and follow all label procedures to a tee.
Pest : Caterpillars
Caterpillars are the immature form of moths and butterflies. They are voracious feeders attacking a wide variety of plants. They can be highly destructive and are characterized as leaf feeders, stem borers, leaf rollers, cutworms and tent-formers.
Prevention and Control: keep weeds down, scout individual plants and remove caterpillars, apply labeled insecticides such as soaps and oils, take advantage of natural enemies such as parasitic wasps in the garden and use Bacillus thuringiensis (biological warfare) for some caterpillar species.
Pest : Scale Insects
Scales are insects, related to mealy bugs, that can be a problem on a wide variety of plants - indoor and outdoor. Young scales crawl until they find a good feeding site. The adult females then lose their legs and remain on a spot protected by its hard shell layer. They appear as bumps, often on the lower sides of leaves. They have piercing mouth parts that suck the sap out of plant tissue. Scales can weaken a plant leading to yellow foliage and leaf drop. They also produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface fungal growth called sooty mold.
Prevention and Control: Once established they are hard to control. Isolate infested plants away from those that are not infested. Consult your local garden center professional or Cooperative Extension office in your county for a legal recommendation regarding their control. Encourage natural enemies such as parasitic wasps in the garden.
Diseases : Blight
Blights are cause by fungi or bacteria that kill plant tissue. Symptoms often show up as the
rapid spotting or wilting of foliage. There are many different blights, specific
to various plants, each requiring a varied method of control.
Diseases : Apple Scab
Apple Scab fungus thrives in cool, moist areas and overwinters in infected
leaves that have fallen to the ground. In spring, spores infect new leaves, stems,
flowers and fruit. If conditions are right (wet and 70 degrees), the fungus can
infect the fruit around the bloom in just 6 hours, though visible signs may not
be noticed for a couple of weeks.
Infection first appears as a dark green or black irregular patch on leaf surfaces.
It is not uncommon for leaves to pucker and become discolored and eventually fall
of the tree. Scab on fruit shows up as a brownish patch with a white halo. Older
lesions will not have the halo.
Prevention and Control: Plant resistant varieties whenever possible. Remember, resistant does not mean immune. Keep trees properly pruned
to promote good air circulation and always rake up and destroy fallen leaves. If
you have a known problem from previous years, treat with an appropriate fungicide early on. Follow all directions on the label - make sure the fungicide you select is labelled for use on that plant to control apple scab It is too late to treat if you see scab on fruit and trees.
Fungi : Cedar Apple Rust
Cedar Apple Rust requires two alternate hosts each year: cedar or juniper
type plants and apples, crabapples or hawthorn. Between spring and early summer,
infected juniper or cedar leaves and stems may swell with greenish-brown galls. By fall,
the galls have developed dimples. Though these do no immediate harm to the plant,
by the following spring, when weather is wet and warm, the galls swell and develop
jelly-like horn protrusions. Spores produced by these horns then infect apple trees.
Wind carried spores are capable of infecting trees up to 4 miles away. On apples,
cedar apple rust appears as rusty orange spots, having a ring-like appearance. Fruit
drop is also common.
Prevention and Control Plant resistant varieties and eliminate hosts
from the area. Chinese and Savin Junipers seem to be resistant as are apple
varieties Freedom, Liberty, and Priscilla. Always rake-up and destroy
diseased or damaged fruit and leaves. There are no chemicals available
labeled for home gardener use.
Conditions : Fall Color
Fall color is the result of trees or shrubs changing colors according to complex chemical formulas present in their leaves. Depending on how much iron, magnesium, phosphorus, or sodium is in the plant, and the acidity of the chemicals in the leaves, leaves might turn amber, gold, red, orange or just fade from green to brown. Scarlet oaks, red maples and sumacs, for instance, have a slightly acidic sap, which causes the leaves to turn bright red. The leaves of some varieties of ash, growing in areas where limestone is present, will turn a regal purplish-blue.
Although many people believe that cooler temperatures are responsible for the color change, the weather has nothing to do with it at all. As the days grow shorter and the nights longer, a chemical clock inside the trees starts up, releasing a hormone which restricts the flow of sap to each leaf. As fall progresses, the sap flow slows and chlorophyll, the chemical that gives the leaves their green color in the spring and summer, disappears. The residual sap becomes more concentrated as it dries, creating the colors of fall.
Glossary : Specimen
A specimen can be a tree, shrub, ground cover, annual, or perennial that is unique in comparison to the surrounding plants. Uniqueness may be in color, form, texture, or size. By using only one specimen plant in a visual area, it can be showcased. Specimen plants are accents in the landscape, just as statues, water features, or arbors.