Oenothera speciosa ( Childsii Sundrops )

Characteristics

Cultivar:	Childsii
Family:	Onagraceae
Size:	Height: 0 ft. to 1 ft. Width: 0 ft. to 0 ft.
Plant Category:	perennials,
Plant Characteristics:	low maintenance, spreading,
Foliage Characteristics:	medium leaves,
Foliage Color:	green,
Flower Characteristics:	fragrant, showy,
Flower Color:	pinks,
Tolerances:	drought, pollution,

Requirements

Bloomtime Range:	Early Summer to Early Fall
USDA Hardiness Zone:	5 to 8
AHS Heat Zone:	Not defined for this plant
Light Range:	Sun to Full Sun
pH Range:	5.5 to 8.5
Soil Range:	Mostly Sand to Clay Loam
Water Range:	Semi-Arid to Normal

Plant Care

Fertilizing

Light

Conditions : Light and Plant Selection

For best plant performance, it is desirable to match the correct plant with the available light conditions. Right plant, right place! Plants which do not receive sufficient light may become pale in color, have fewer leaves and a "leggy" stretched-out appearance. Also expect plants to grow slower and have fewer blooms when light is less than desirable. It is possible to provide supplemental lighting for indoor plants with lamps. Plants can also receive too much light. If a shade loving plant is exposed to direct sun, it may wilt and/or cause leaves to be sunburned or otherwise damaged.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Conditions : Semi-Arid

Semi-Arid is defined as very little water/rainfall occurring only during certain times of the season.

Conditions : Dry

Dry is defined as an area that regularly receives water, but is fast draining. This results in a soil that is often dry to a depth of 18 inches.

Conditions : Normal

Normal is defined as regular watering to a depth of 18 inches, but periodically dries out in the top 7 inches between waterings.

Planting

How-to : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

How-to : Planting Perennials

Determine appropriate perennials for your garden by considering sun and shade through the day, exposure, water requirements, climate, soil makeup, seasonal color desired, and position of other garden plants and trees.

The best times to plant are spring and fall, when soil is workable and out of danger of frost. Fall plantings have the advantage that roots can develop and not have to compete with developing top growth as in the spring. Spring is more desirable for perennials that dislike wet conditions or for colder areas, allowing full establishment before first winter. Planting in summer or winter is not advisable for most plants, unless planting a more established sized plant.

To plant container-grown plants: Prepare planting holes with appropriate depth and space between. Water the plant thoroughly and let the excess water drain before carefully removing from the container. Carefully loosen the root ball and place the plant in the hole, working soil around the roots as you fill. If the plant is extremely root bound, separate roots with fingers. A few slits made with a pocket knife are okay, but should be kept to a minimum. Continue filling in soil and water thoroughly, protecting from direct sun until stable.

To plant bare-root plants: Plant as soon as possible after purchase. Prepare suitable planting holes, spread roots and work soil among roots as you fill in. Water well and protect from direct sun until stable.

To plant seedlings: A number of perennials produce self-sown seedlings that can be transplanted. You may also start your own seedling bed for transplanting. Prepare suitable planting holes, spacing appropriately for plant development. Gently lift the seedling and as much surrounding soil as possible with your garden trowel, and replant it immediately, firming soil with fingertips and water well. Shade from direct sun and water regularly until stable.

Problems

Fungi : Rusts

Most rusts are host specific and overwinter on leaves, stems and spent flower debris. Rust often appears as small, bright orange, yellow, or brown pustules on the underside of leaves. If touched, it will leave a colored spot of spores on the finger. Caused by fungi and spread by splashing water or rain, rust is worse when weather is moist.

Prevention and Control: Plant resistant varieties and provide maximum air circulation. Clean up all debris, especially around plants that have had a problem. Do not water from overhead and water only during the day so that plants will have enough time to dry before night. Apply a fungicide labeled for rust on your plant.

Fungi : Powdery Mildew

Powdery Mildew is usually found on plants that do not have enough air circulation or adequate light. Problems are worse where nights are cool and days are warm and humid. The powdery white or gray fungus is usually found on the upper surface of leaves or fruit. Leaves will often turn yellow or brown, curl up, and drop off. New foliage emerges crinkled and distorted. Fruit will be dwarfed and often drops early.

Prevention and Control: Plant resistant varieties and space plants properly so they receive adequate light and air circulation. Always water from below, keeping water off the foliage. This is paramount for roses. Go easy on the nitrogen fertilizer. Apply fungicides according to label directions before problem becomes severe and follow directions exactly, not missing any required treatments. Sanitation is a must - clean up and remove all leaves, flowers, or debris in the fall and destroy.

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.

Fungi : Downy Mildew

Downy Mildew, a fluffy white fungal growth that develops on the underside of leaves, is most common during cool, humid conditions. Foliage often discolors and is stunted.

Prevention and Control: Use disease free plants and space far enough apart so that air circulation is good. Remove and discard infected leaves or even entire plants. Use a recommended fungicide and always follow the directions on the label.

Miscellaneous

Conditions : Pollution Tolerant

Air pollution is becoming a bigger problem each day. Pollutants in our air damage plants. The plants are damaged by absorbing sulfur dioxide, ozone, peroxyacetyl nitrate, ethylene, and nitrogen dioxide through their pores. Cell membrane damage may result in leaf drop, blotched or burnt looking leaves, or off-colored tissue between veins. Vehicles and industrial processes are the key culprits and conditions worsen on hot summer days. Though planting only pollution tolerant plants is not the solution to this problem, it is a visual band aid. Your Cooperative Extension Service may have a list of plants that are more pollution tolerant in your area.

Glossary : Low Maintenance

Low maintenance does not mean no maintenance. It does mean that once a plant is established, very little needs to be done in the way of water, fertilizing, pruning, or treatment in order for the plant to remain healthy and attractive. A well-designed garden, which takes your lifestyle into consideration, can greatly reduce maintenance.

Glossary : Southwest

Southwest refers to plants native to parts of, or all of, the southwestern regions of Arizona, New Mexico, southwestern Colorado, southern Utah, Nevada, western Texas, southeastern California.

Glossary : pH

pH, means the potential of Hydrogen, is the measure of alkalinity or acidity. In horticulture, pH refers to the pH of soil. The scale measures from 0, most acid, to 14, most alkaline. Seven is neutral. Most plants prefer a range between 5.5 and about 6.7, an acid range, but there are plenty of other plants that like soil more alkaline, or above 7. A pH of 7 is where the plant can most easily absorb the most nutrients in the soil. Some plants prefer more or less of certain nutrients, and therefore do better at a certain pH.

Glossary : U. S. Natives

Native plants require lower maintenance and usually have less pest problems. They are key components in the xeriphytic landscape and backyard wildlife habitat. Select your region and the search will look for all plants in the database that are native to your area.

Plant Images