Dicksonia ( Dicksonia )

Characteristics

Cultivar:	n/a
Family:	Dicksoniaceae
Size:	Height: 3 ft. to 10 ft. Width: 3 ft. to 6 ft.
Plant Category:	ferns and moss,
Plant Characteristics:	vase-shaped,
Foliage Characteristics:	coarse leaves, evergreen,
Foliage Color:	green,
Flower Characteristics:
Flower Color:
Tolerances:	heat & humidity,

Requirements

Bloomtime Range:	not applicable
USDA Hardiness Zone:	9 to 11
AHS Heat Zone:	Not defined for this plant
Light Range:	Shade to Part Shade
pH Range:	4.5 to 6.5
Soil Range:	Sandy Loam to Potting Soil
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilize Monthly

Now is the time to begin fertilizing with a water-soluble fertilizer. Continue through the end of summer.

Light

Conditions : Partial Shade

Partial Shade is defined as filtered light found beneath trees with high limbs. Partial shade usually offers some protection from direct afternoon sun.

Conditions : Dappled Light

Dappled Light refers to a dappled pattern of light created on the ground, as cast by light passing through high tree branches. This is the middle ground, not considered shady, but not sunny either. Dappled remains constant throughout the day.

Conditions : Full to Partial Shade

Full shade means there is little or no light in the growing zone. Shade can be the result of a mature stand of trees or shadows cast by a house or building. Plants that require full shade are usually susceptible to sunburn. Full shade beneath trees may pose additional problems; not only is there no light, but competition for water, nutrients and root space.

Partial shade means that an area receives filtered light, often through tall branches of an open growing tree. Root competition is usually less. Partial shade can also be achieved by locating a plant beneath an arbor or lathe-like structure. Shadier sides of a building are normally the northern or northeastern sides. These sides also tend to be a little cooler. It is not uncommon for plants that can tolerate full sun or some sun in cooler climates to require some shade in warmer climates due to stress placed on the plant from reduced moisture and excessive heat.

Watering

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Planting

How-to : Preparing Containers

Containers are excellent when used as an ornamental feature, a planting option when there is little or no soil to plant in, or for plants that require a soil type not found in the garden or when soil drainage in the garden is inferior. If growing more than one plant in a container, make sure that all have similar cultural requirements. Choose a container that is deep and large enough to allow root development and growth as well as proportional balance between the fully developed plant and the container. Plant large containers in the place you intend them to stay. All containers should have drainage holes. A mesh screen, broken clay pot pieces(crock) or a paper coffee filter placed over the hole will keep soil from washing out. The potting soil you select should be an appropriate mix for the plants you have chosen. Quality soils (or soil-less medias) absorb moisture readily and evenly when wet. If water runs off soil upon initial wetting, this is an indicator that your soil may not be as good as you think.

Prior to filling a container with soil, wet potting soil in the bag or place in a tub or wheelbarrow so that it is evenly moist. Fill container about halfway full or to a level that will allow plants, when planted, to be just below the rim of the pot. Rootballs should be level with soil line when project is complete. Water well.

How-to : Planting Perennials

Determine appropriate perennials for your garden by considering sun and shade through the day, exposure, water requirements, climate, soil makeup, seasonal color desired, and position of other garden plants and trees.

The best times to plant are spring and fall, when soil is workable and out of danger of frost. Fall plantings have the advantage that roots can develop and not have to compete with developing top growth as in the spring. Spring is more desirable for perennials that dislike wet conditions or for colder areas, allowing full establishment before first winter. Planting in summer or winter is not advisable for most plants, unless planting a more established sized plant.

To plant container-grown plants: Prepare planting holes with appropriate depth and space between. Water the plant thoroughly and let the excess water drain before carefully removing from the container. Carefully loosen the root ball and place the plant in the hole, working soil around the roots as you fill. If the plant is extremely root bound, separate roots with fingers. A few slits made with a pocket knife are okay, but should be kept to a minimum. Continue filling in soil and water thoroughly, protecting from direct sun until stable.

To plant bare-root plants: Plant as soon as possible after purchase. Prepare suitable planting holes, spread roots and work soil among roots as you fill in. Water well and protect from direct sun until stable.

To plant seedlings: A number of perennials produce self-sown seedlings that can be transplanted. You may also start your own seedling bed for transplanting. Prepare suitable planting holes, spacing appropriately for plant development. Gently lift the seedling and as much surrounding soil as possible with your garden trowel, and replant it immediately, firming soil with fingertips and water well. Shade from direct sun and water regularly until stable.

How-to : Repot

Now is the right time to repot.

Problems

Miscellaneous

Plant Images