Gentianopsis crinita ( Fringed Gentian )

Characteristics

Cultivar:	n/a
Family:	Gentianaceae
Size:	Height: 1 ft. to 3 ft. Width: 0.75 ft. to 0.75 ft.
Plant Category:	annuals and biennials,
Plant Characteristics:	low maintenance,
Foliage Characteristics:	small leaves,
Foliage Color:	green,
Flower Characteristics:	horizontal,
Flower Color:	blues,
Tolerances:	slope, wind,

Requirements

Bloomtime Range:	Early Summer to Mid Summer
USDA Hardiness Zone:	4 to 8
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Shade to Sun
pH Range:	5.5 to 6.5
Soil Range:	Sandy Loam to Loam
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilization for Annuals and Perennials

Annuals and perennials may be fertilized using: 1.water-soluble, quick release fertilizers; 2. temperature controlled slow-release fertilizers; or 3. organic fertilizers such as fish emulsion. Water soluble fertilizers are generally used every two weeks during the growing season or per label instructions. Controlled, slow-release fertilizers are worked into the soil ususally only once during the growing season or per label directions. For organic fertilizers such as fish emulsion, follow label directions as they may vary per product.

Light

Conditions : Partial Shade

Partial Shade is defined as filtered light found beneath trees with high limbs. Partial shade usually offers some protection from direct afternoon sun.

Conditions : Part Sun

Part Sun refers to filtered light, with most sun being received during the afternoon hours. Shade usually occurs during the morning hours.

Conditions : Partial Sun, Partial Shade

Part sun or part shade plants prefer light that is filtered. Sunlight, though not direct, is important to them. Often morning sun, because it is not as strong as afternoon sun, can be considered part sun or part shade. If you live in an area that does not get much intense sun, such as the Pacific Northwest, a full sun exposure may be fine. In other areas such as Florida, plant in a location where afternoon shade will be received.

Watering

Problems : Waterlogged Soil and Solutions

Waterlogged soil occurs when more water is added to soil than can drain out in a reasonable amount of time. This can be a severe problem where water tables are high or soils are compacted. Lack of air space in waterlogged soil makes it almost impossible for soil to drain. Few plants, except for bog plants, can tolerate these conditions. Drainage must be improved if you are not satisfied with bog gardening. Over-watered plants have the same wilted leaves as under-watered plants. Fungi such as Phytophthora and Pythium affect vascular systems, which cause wilt.

If the problem is only on the surface, it maybe diverted to a drainage ditch. If drainage is poor where water table is high, install an underground drainage system. You should contact a contractor for this. If underground drains already exist, check to see if they are blocked.

French drains are another option. French drains are ditches that have been filled with gravel. It is okay to plant sod on top of them. More obtrusive, but a good solution where looks aren't as important, think of the French drain as a ditch filled with gravel. Ditches should be 3 to 4 feet deep and have sloping sides.

A soakway is a gravel filled pit where water is diverted to via underground pipes. This works well on sites that have compacted soil. Your soakway should be about 6'wide and deep and filled with gravel or crushed stone, topped with sand and sodded or seeded.

Keep in mind that it is illegal to divert water onto other people's property. If you do not feel that you can implement a workable solution on your own, call a contractor.

Tools : Watering Aides

No gardener depends 100% on natural rainfall. Even the most water conscious garden appreciates the proper hose, watering can or wand.

Watering Cans: Whether you choose plastic of galvanized makes no difference, but do look for generous capacity and a design that is balanced when filled with water. A 2 gallon can (which holds 18 lbs. of water) is preferred by most gardeners and is best suited for outdoor use. Indoor cans should be relatively smaller with narrower spouts and roses (the filter head).

Watering Hose: When purchasing a hose, look for one that is double-walled, as it will resist kinking. Quick coupler links are nice to have on ends of hoses to make altering length fast. To extend the life of your hose, keep it wound around a reel and stored in a shady area. Prior to winter freezes, drain hose.

Sprayers: Are commonly thought of as devices for applying chemicals, but can really be a step saver for watering houseplants or small pots of annuals rather that dragging out a hose or making numerous trips with a watering can. The backpack sprayer is best suited for this. Take care not to use any kind of chemical in tanks used for watering!

Sprinklers: Attached to the ends of garden hoses, these act as an economical irrigation system. Standing Spike Sprinklers are usually intended for lawns and deliver water in a circular pattern. Rotating Sprinklers deliver a circle of water and are perfect for lawns, shrubs and flower beds. Pulse-jet sprinklers cover large areas of ground in a pulsating, circular pattern. The head usually sits up on a tall stem, except for when watering lawns. Oscillating sprinklers are best for watering at ground level in a rectangular pattern.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Planting

How-to : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

How-to : Planting and Removing Annuals

When planting annuals, begin by preparing the soil. Rototill rotted compost, soil conditioner, pulverized bark, or even builders sand into the existing soil and rake it smooth. Annuals grow quickly, so space them as recommended on plant tags. Remove plants from their containers or packs gently, being sure to keep as much soil as you can around the root ball. If the rootball is tight, loosen it a bit by gently separating white, matted roots with your fingers or a pocket knife. Plant at the same depth they were in the containers. Gently fill in around the plants, providing support but not cutting off air to the roots. Water the plants well.

Through the season, be sure to fertilize for optimal performance. Take special care to cut back or completely remove any diseased plants, as soon as you see there is a problem. At the end of the season, be sure to remove all plants and their root balls. Rake the bed well to prepare it for the next season's planting.

Problems

Pest : Slugs and Snails

Slugs and snails favor moist climates and are mollusks, not insects. They can be voracious feeders, eating just about anything that is not woody or highly scented. They may eat holes in leaves, strip entire stems, or completely devour seedlings and tender transplants, leaving behind tell-tale silvery, slimy trails.

Prevention and control: Keep your garden as clean as possible, eliminating hiding places such as leaf debris, over-turned pots, and tarps. Groundcover in shady places and heavy mulches provide protection from the elements and can be favorite hiding places. In the spring, patrol for and destroy eggs (clusters of small translucent spheres) and adults during dusk and dawn. Set out beer traps from late spring through fall.

Many chemical controls are available on the market, but can be poisonous and deadly for children and pets; take care when using them - always read the label first!

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.

Weeds : Preventing Weeds and Grass

Weeds rob your plants of water, nutrients and light. They can harbor pests and diseases. Before planting, remove weeds either by hand or by spraying an herbicide according to label directions. Another alternative is to lay plastic over the area for a couple of months to kill grass and weeds.

You may apply a pre-emergent herbicide prior to planting, but be sure that it is labeled for the plants you are wishing to grow. Existing beds may be spot sprayed with a nonselective herbicide, but be careful to shield those plants you do not want to kill. Non-selective means that it will kill everything it comes in contact with.

Mulch plants with a 3 inch layer of pinestraw, pulverized bark, or compost. Mulch conserves moisture, keeps weeds down, and makes it easier to pull when necessary.

Porous landscape or open weave fabric works too, allowing air and water to be exchanged.

Miscellaneous

Conditions : Slope Tolerant

Slope tolerant plants are those that have a fibrous root system and are often plants that prefer good soil drainage. These plants assist in erosion control by stabilizing/holding the soil on slopes intact.

Conditions : Wind Tolerant

Plants that are wind tolerant usually have flexible, strong branches that are not brittle. Wind tolerant plants often have thick or waxy leaves that control moisture loss from whipping winds. Native plants are often the best adapted to not only wind, but also soil and other climatic conditions.

Glossary : Border Plant

A border plant is one which looks especially nice when used next to other plants in a border. Borders are different from hedges in that they are not clipped. Borders are loose and billowy, often dotted with deciduous flowering shrubs. For best effect, mass smaller plants in groups of 3, 5, 7, or 9. Larger plants may stand alone, or if room permits, group several layers of plants for a dramatic impact. Borders are nice because they define property lines and can screen out bad views and offer seasonal color. Many gardeners use the border to add year round color and interest to the garden.

Glossary : Annual

An annual is any plant that completes its life cycle in one growing season.

Glossary : Biennial

Biennial is a plant that takes two growing seasons to produce flowers and fruit. The first growing season, the plant stays in a rosette form, producing mainly foliage and roots. The second growing season the plant bolts, producing flowers and fruits or seeds.

Glossary : pH

pH, means the potential of Hydrogen, is the measure of alkalinity or acidity. In horticulture, pH refers to the pH of soil. The scale measures from 0, most acid, to 14, most alkaline. Seven is neutral. Most plants prefer a range between 5.5 and about 6.7, an acid range, but there are plenty of other plants that like soil more alkaline, or above 7. A pH of 7 is where the plant can most easily absorb the most nutrients in the soil. Some plants prefer more or less of certain nutrients, and therefore do better at a certain pH.

Glossary : Heat Zone

The 12 zones of the AHS Heat Zone map indicate the average number of days each year that a given region experiences ""heat days"" or temperatures over 86 degrees F(30 degrees Celsius). That is the point at which plants begin suffering physiological damage from heat. The zones range from Zone 1 (less than one heat day) to Zone 12 (more than 210 heat days). The AHS Heat Zone, which deals with heat tolerance, should not be confused with the USDA Hardiness Zone system which deals with cold tolerance. For example: Seattle, Washington has a USDA Hardiness Zone of 8, the same as Charleston, South Carolina; however Seattle's Heat Zone is 2 where Charleston's Heat Zone is 11. What this says is that winter temperature in the two cities may be similar, but because Charleston has significantly warmer weather for a longer period of time, plant selection based on heat tolerance is a factor to consider.

Glossary : Plant Characteristics

Plant characteristics define the plant, enabling a search that finds specific types of plants such as bulbs, trees, shrubs, grass, perennials, etc.

Glossary : Flower Characteristics

Flower characteristics can vary greatly and may help you decide on a ""look or feel"" for your garden. If you're looking for fragrance or large, showy flowers, click these boxes and possibilities that fit your cultural conditions will be shown. If you have no preference, leave boxes unchecked to return a greater number of possibilities.

Glossary : Foliage Characteristics

By searching foliage characteristics, you will have the opportunity to look for foliage with distinguishable features such as variegated leaves, aromatic foliage, or unusual texture, color or shape. This field will be most helpful to you if you are looking for accent plants. If you have no preference, leave this field blank to return a larger selection of plants.

Glossary : Soil Types

A soil type is defined by granule size, drainage, and amount of organic material in the soil. The three main soil types are sand, loam and clay. Sand has the largest particle size, no organic matter, little to no fertility, and drains rapidly. Clay, at the opposite end of the spectrum, has the smallest particle size, can be rich in organic matter, fertility and moisture, but is often unworkable because particles are held together too tightly, resulting in poor drainage when wet, or is brick-like when dry. The optimum soil type is loam, which is the happy median between sand and clay: It is high in organic matter, nutrient-rich, and has the perfect water holding capacity.

You will often hear loam referred to as a sandy loam (having more sand, yet still plenty of organic matter) or a clay loam (heavier on the clay, yet workable with good drainage.) The addition of organic matter to either sand or clay will result in a loamy soil. Still not sure if your soil is a sand, clay, or loam? Try this simple test. Squeeze a handfull of slightly moist, not wet, soil in your hand. If it forms a tight ball and does not fall apart when gently tapped with a finger, your soil is more than likely clay. If soil does not form a ball or crumbles before it is tapped, it is sand to very sandy loam. If soil forms a ball, then crumbles readily when lightly tapped, it's a loam. Several quick, light taps could mean a clay loam.

Glossary : Wind Break

A wind break is any group of plants used to break up or deflect the wind. Large scale windbreaks are usually planted as a single or double row and may be used not only to protect buildings, but crops as well. The exact placement of the windbreak depends on its height and the velocity of the wind.

Wind break plants are usually planted close together. Combination plantings seem to work well too: taller plants should be in the middle, shorter on the outsides.

Plant Images