garden
gardening
gardening
garden seeds
gardening gardening gardening garden
gardening
gardening
gardening gardening
Google Plant Images

Archontophoenix alexandrae
( Northern Bangalow Palm )

Usually found in rainforest areas of Australia. In temperate climates these palms grow well as specimen trees. Tall palm with slim, ringed trunk. Leaves are 6 to 12 feet long, pinnate, arching, and made up of many leaflets in light to grayish green. Pendent racemes of lilac flowers bloom in summer followed by round red fruit.


How to Grow this Plant:


Where can you buy this plant: click here!

Characteristics
Cultivar:n/a  
Family:Arecaeae  
Size:Height: 0 ft. to 80 ft.
Width: 15 ft. to 20 ft.  
Plant Category:houseplants, palms and cycads, trees,  
Plant Characteristics:columnar, decorative berries or fruit,  
Foliage Characteristics:coarse leaves,  
Foliage Color:green,  
Flower Characteristics:nodding, showy,  
Flower Color:creams, yellows,  
Tolerances:deer,  
Requirements
Bloomtime Range:Early Summer to Late Summer  
USDA Hardiness Zone:10 to 11  
AHS Heat Zone:Not defined for this plant  
Light Range:Part Shade to Part Shade  
pH Range:5.5 to 6.5  
Soil Range:Sandy Loam to Clay Loam  
Water Range:Normal to Moist  

Plant Care



Fertilizing
How-to : Fertilization for Established Plants

Established plants can benefit from fertilization. Take a visual inventory of your landscape. Trees need to be fertilized every few years. Shrubs and other plants in the landscape can be fertilized yearly. A soil test can determine existing nutrient levels in the soil. If one or more nutrients is low, a specific instead of an all-purpose fertilizer may be required. Fertilizers that are high in N, nitrogen, will promote green leafy growth. Excess nitrogen in the soil can cause excessive vegetative growth on plants at the expense of flower bud development. It is best to avoid fertilizing late in the growing season. Applications made at that time can force lush, vegetative growth that will not have a chance to harden off before the onset of cold weather.

Light
Conditions : Partial Shade

Partial Shade is defined as filtered light found beneath trees with high limbs. Partial shade usually offers some protection from direct afternoon sun.

Watering
Conditions : Normal Watering for Houseplants

Houseplants that require normal watering should be watered so that soil is completely saturated and excess water runs out the bottom of the pot. Never water just a little bit; this allows mineral salts to build up in the soil. The key to normal watering is to allow the top inch or two of potting soil to dry out between waterings. Check frequently as certain times of the year may dictate that you water more frequently. Also, some plants that require normal watering during the growing season, may require less during the winter months when they are dormant.

Conditions : Regular Moisture for Outdoor Plants

Water when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not to overwater. The first two years after a plant is installed, regular watering is important. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Conditions : Indoor Watering

Plant are composed of almost 90% water so it important to supply them with adequate water. Proper watering is essential for good plant health. When there is not enough water, roots will wither and the plant will wilt. When too much water is applied too frequently, roots are deprived of oxygen and diseases occur such as root and stem rots.

The type of plant, plant age, light level, soil type and container size all will impact when a plant needs to be watered. Follow these tips to ensure successful watering:

* The key to watering is frequency. Water well then wait long enough until the plant needs to be re-watered according to its moisture requirements.

* When watering, water well. That is, provide enough water to thoroughly saturate the root ball. With containerized plants, apply enough water to allow water to flow through the drainage holes.

* Avoid using cold water especially with houseplants. This can shock tender roots. Fill watering can with tepid water or allow cold water to sit for a while to come to room temperature before watering. This is a good way to allow any harmful chlorine in the water to evaporate before being used.

* Some plants are best irrigated by sub-irrigation, i.e. watering from the bottom up. This avoids splashing water on the leaves of sensitive plants. Simply place the pot in a shallow pan filled with tepid water and let the plant sit for 15 minutes to allow the root ball to be thoroughly wet. Take out and allow sufficient drainage.

* Use an unpainted dowel to help you determine when to re-water larger pots. Stick it into the soil ball & wait 5 minutes. The dowel will absorb moisture from the soil and turn a darker color. Pull it out and examine. This will give you an idea of how wet the soil root ball is.

* Roots need oxygen to breath, do not allow plants to sit in a saucer filled with water. This will only promote disease.

Planting
How-to : Pruning Trees After Planting

It is critical to prune trees correctly from the beginning to assure proper growth and development. Young trees can be transplanted in a number of forms: bare root, balled & burlap and in containers. The more stress the plant undergoes in the transplant process, the more pruning that is required to compensate.

Deciduous trees like maples (those that loose their leaves in the fall) can be dug up and sold with their bare roots exposed. Because most of the root system is lost in digging, sufficient top growth should be removed to compensate for this loss. This may be done at the nursery before you buy the plant or you may have to prune at the time of planting. Select and head back the best scaffold branches, i.e. those branches which will form the main lateral structure of the future mature tree. Remove all other extraneous side branches. If the tree seedling does not have branches, allow it to grow to the desired height of branching then pinch it back to stimulate the lower buds to form branches.

Ball and burlap trees are dug up with their root systems somewhat intact. This was mostly done for conifers and broadleaf evergreens, but has become common for deciduous trees as well. Since some root mass is lost in the digging stage, a light pruning is generally called for. Head back the plant to compensate for this loss and to promote branching.

Trees that are grown in containers generally do not loose roots in the transplanting phase. Therefore you do not generally have to prune them unless there is some root injury or limb damage in the planting process.

Once you have your trees planted, be patient. Do not remove shoots from the trunk early on as these allow the tree to grow more rapidly and also shade the tender young trunk from sun-scald. Wait a few years to begin training the tree to its ultimate form.

How-to : Planting a Tree

Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.

If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.

If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.

Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.

Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.

Problems
Pest : Spider Mites

Spider mites are small, 8 legged, spider-like creatures which thrive in hot, dry conditions (like heated houses). Spider mites feed with piercing mouth parts, which cause plants to appear yellow and stippled. Leaf drop and plant death can occur with heavy infestations. Spider mites can multiply quickly, as a female can lay up to 200 eggs in a life span of 30 days. They also produce a web which can cover infested leaves and flowers.

Prevention and Control: Keep weeds down and remove infested plants. Dry air seems to worsen the problem, so make sure plants are regularly watered, especially those preferring high humidity such as tropicals, citrus, or tomatoes. Always check new plants prior to bringing them home from the garden center or nursery. Take advantage of natural enemies such as ladybug larvae. If a miticide is recommended by your local garden center professional or county Cooperative Extension office, read and follow all label directions. Concentrate your efforts on the undersides of the leaves as that is where spider mites generally live.

Diseases : Pythium and Phytophtora Root Rot

Rot Rot, Pythium or Phytophthora occurs when soil moisture levels are excessively high and fungal spores present in the soil, come in contact with the susceptible plant. The base of stems discolor and shrink, and leaves further up the stalk wilt and die. Leaves near base are affected first. The roots will turn black and rot or break. This fungi can be introduced by using unsterilized soil mix or contaminated water.

Prevention and Control Remove affected plants and their roots, and discard surrounding soil. Replace with plants that are not susceptible, and only use fresh, sterilized soil mix. Hold back on fertilizing too. Try not to over water plants and make sure that soil is well drained prior to planting. This fungus is not treatable by chemicals.

Rhizoctonia Root and Stem Rot symptoms look similar to Pythium Root Rot, but the Rhizoctonia fungus seems to thrive in well drained soils.

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.



Miscellaneous
Conditions : Deer Tolerant

There are no plants that are 100% deer resistant, but many that are deer tolerant. There are plants that deer prefer over others. You will find that what deer will or will not eat varies in different parts of the country. A lot of it has to do with how hungry they are. Most deer will sample everything at least once, decide if they like it or not and return if favorable. A fence is the good deer barrier. You may go for a really tall one (7 to 8 feet), or try 2 parallel fences, (4 to 5 feet apart). Use a wire mesh fence rather than board, since deer are capable of wiggling through a 12 inch space.

Glossary : Specimen

A specimen can be a tree, shrub, ground cover, annual, or perennial that is unique in comparison to the surrounding plants. Uniqueness may be in color, form, texture, or size. By using only one specimen plant in a visual area, it can be showcased. Specimen plants are accents in the landscape, just as statues, water features, or arbors.

Glossary : Evergreen

Evergreen refers to plants that hold onto their leaves or needles for more than one growing season, shedding them over time. Some plants such as live oaks are evergreen, but commonly shed the majority of their older leaves around the end of January.

Glossary : Large Tree

A tree is considered large when it is over 30 feet tall.

Plant Images






Free Garden Catalog



 

gardening gardening



Free gardeing catalog gardening


g gardening garden seeds gardening
gardening
gardening