Antirrhinum majus ( Black Prince Snapdragon )

Characteristics

Cultivar:	Black Prince
Family:	Scrophulariaceae
Size:	Height: 0 ft. to 1.5 ft. Width: 0 ft. to 0 ft.
Plant Category:	annuals and biennials, perennials,
Plant Characteristics:	seed start,
Foliage Characteristics:
Foliage Color:	dark green,
Flower Characteristics:	unusual,
Flower Color:	burgundy, reds,
Tolerances:

Requirements

Bloomtime Range:	Early Summer to Mid Fall
USDA Hardiness Zone:	6 to 10
AHS Heat Zone:	1 to 1
Light Range:	Part Sun to Full Sun
pH Range:	6.5 to 7
Soil Range:	Sandy Loam to Clay Loam
Water Range:	Normal to Normal

Plant Care

Fertilizing

How-to : Fertilization for Annuals and Perennials

Annuals and perennials may be fertilized using: 1.water-soluble, quick release fertilizers; 2. temperature controlled slow-release fertilizers; or 3. organic fertilizers such as fish emulsion. Water soluble fertilizers are generally used every two weeks during the growing season or per label instructions. Controlled, slow-release fertilizers are worked into the soil ususally only once during the growing season or per label directions. For organic fertilizers such as fish emulsion, follow label directions as they may vary per product.

Light

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Planting

How-to : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

How-to : Planting and Removing Annuals

When planting annuals, begin by preparing the soil. Rototill rotted compost, soil conditioner, pulverized bark, or even builders sand into the existing soil and rake it smooth. Annuals grow quickly, so space them as recommended on plant tags. Remove plants from their containers or packs gently, being sure to keep as much soil as you can around the root ball. If the rootball is tight, loosen it a bit by gently separating white, matted roots with your fingers or a pocket knife. Plant at the same depth they were in the containers. Gently fill in around the plants, providing support but not cutting off air to the roots. Water the plants well.

Through the season, be sure to fertilize for optimal performance. Take special care to cut back or completely remove any diseased plants, as soon as you see there is a problem. At the end of the season, be sure to remove all plants and their root balls. Rake the bed well to prepare it for the next season's planting.

How-to : Pinching and Thinning Perennials

Once you plant a perennial, it does not mean that you will enjoy years of maintenance-free gardening. Perennials need to be cared for just like any other plant. One thing that distinguishes perennials is that they tend to be active growers that have to be thinned out occasionally or they will loose vigor.

As perennials establish, it is important to prune them back and thin them out occasionally. This will prevent them from completely taking over an area to the exclusion of other plants, and also will increase air circulation thereby reducing the incidence of diseases like botrytis and powdery mildew.

Many species also flower abundantly and produce ample seed. As blooms fade it is advisable to deadhead your plant; that is, to remove spent flowers before they form seed. This will prevent your plants from seeding all over the garden and will conserve the considerable energy it takes the plant to produce seed.

As perennials mature, they may form a dense root mass that eventually leads to a less vigorous plant. It is advisable to occasionally thin out a stand of such perennials. By dividing the root system, you can make new plants to plant in another area of the garden or give away. Also root pruning will stimulate new growth and rejuvenate the plant. Most perennials may be successfully divided in either spring or fall. Do a little homework; some perennials do have a preference.

Problems

Pest : Aphids

Aphids are small, soft-bodied, slow-moving insects that suck fluids from plants. Aphids come in many colors, ranging from green to brown to black, and they may have wings. They attack a wide range of plant species causing stunting, deformed leaves and buds. They can transmit harmful plant viruses with their piercing/sucking mouthparts. Aphids, generally, are merely a nuisance, since it takes many of them to cause serious plant damage. However aphids do produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface growth called sooty mold.

Aphids can increase quickly in numbers and each female can produce up to 250 live nymphs in the course of a month without mating. Aphids often appear when the environment changes - spring & fall. They're often massed at the tips of branches feeding on succulent tissue. Aphids are attracted to the color yellow and will often hitchhike on yellow clothing.

Prevention and Control: Keep weeds to an absolute minimum, especially around desirable plants. On edibles, wash off infected area of plant. Lady bugs and lacewings will feed on aphids in the garden. There are various products - organic and inorganic - that can be used to control aphids. Seek the recommendation of a professional and follow all label procedures to a tee.

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.

Weeds : Preventing Weeds and Grass

Weeds rob your plants of water, nutrients and light. They can harbor pests and diseases. Before planting, remove weeds either by hand or by spraying an herbicide according to label directions. Another alternative is to lay plastic over the area for a couple of months to kill grass and weeds.

You may apply a pre-emergent herbicide prior to planting, but be sure that it is labeled for the plants you are wishing to grow. Existing beds may be spot sprayed with a nonselective herbicide, but be careful to shield those plants you do not want to kill. Non-selective means that it will kill everything it comes in contact with.

Mulch plants with a 3 inch layer of pinestraw, pulverized bark, or compost. Mulch conserves moisture, keeps weeds down, and makes it easier to pull when necessary.

Porous landscape or open weave fabric works too, allowing air and water to be exchanged.

Pest : Leaf Miners

Leaf Miner is actually a term that applies to various larvae (of moths, beetles, and flies) that tunnel between upper and lower leaf surfaces, leaving a distinctive, squiggly pattern. A female adult can lay several hundred eggs inside the leaf which hatch and give rise to miners. Leaf miners attack ornamentals and vegetables.

Prevention and Control: Keep weeds down and scout individual plants for tell-tale squiggles. Pick and destroy these leaves and take advantage of natural enemies such as parasitic wasps. Know the Growing Degree Days (GDD)* for your area to target insecticide sprays when most beneficial for controlling the specific leaf miner. Seek a professional recommendation and follow all label procedures to a tee. *GDD numbers should be available from your local Cooperative Extension office.

Diseases : Southern Blight

Plants with Southern blight have lesions on the stem at, or near, the soil line. These lesions develop rapidly, girdling the stem and resulting in a sudden and permanent wilting of the plant. High temperatures (above 85 degrees F, 29 degrees C) favor the disease. The fungus attacks a wide range of plants and survives for long periods in soil. To control, treat with a recommended fungicide according to label directions.

Miscellaneous

How-to : Cut Flowers

Flowers suitable for cutting maintain their form for several days when properly conditioned and placed in water or soaked oasis. A cut flower should have a fairly strong, long stem, making it easy to work with in arrangements. There are many short stem flowers that make good cut flowers too, but they look best when floated in a bowl or clustered and placed in a juice glass size vase.

For best results, always cut flowers early in the morning, preferably before dew has had a chance to dry. Always make cuts with a sharp knife or pruners and plunge flowers or foliage into a bucket of water. Store in a cool place until you are ready to work with them, this will keep flowers from opening. Always re-cut stems and change water frequently. Washing vases or containers to rid of existing bacteria helps increase their life, as well.

Glossary : Border Plant

A border plant is one which looks especially nice when used next to other plants in a border. Borders are different from hedges in that they are not clipped. Borders are loose and billowy, often dotted with deciduous flowering shrubs. For best effect, mass smaller plants in groups of 3, 5, 7, or 9. Larger plants may stand alone, or if room permits, group several layers of plants for a dramatic impact. Borders are nice because they define property lines and can screen out bad views and offer seasonal color. Many gardeners use the border to add year round color and interest to the garden.

Glossary : Mass Planting

Mass is one of the elements of design and relates directly to balance. Mass planting is defined as the grouping of three or more of the same type of plants in one area. When massing plants, keep in mind what visual effect they will have. Small properties require smaller masses where larger properties can handle larger masses or sweeps of plants.

Glossary : Annual

An annual is any plant that completes its life cycle in one growing season.

Glossary : Perennial

Perennial: traditionally a non-woody plant that lives for two or more growing seasons.

Glossary : Flower Characteristics

Flower characteristics can vary greatly and may help you decide on a ""look or feel"" for your garden. If you're looking for fragrance or large, showy flowers, click these boxes and possibilities that fit your cultural conditions will be shown. If you have no preference, leave boxes unchecked to return a greater number of possibilities.

How-to : Getting the Most Out of Cut Flowers

Cut flowers bring the garden into your home. While some cut flowers have a long vase life, most are highly perishable. How cut flowers are treated when you first bring them home can significantly increase how long they last.

The most important thing to consider is getting sufficient water taken up into the cut stem. Insufficient water can result in wilting and short-lived flowers. Bent neck of roses, where the flower head droops, is the result of poor water uptake. To maximize water uptake, first re-cut the stems at an angle so that the vascular system (the ""plumbing"" of the stem) is clear. Next immerse the cut stems in warm water.

Remember when the flower is cut, it is cut off from its food supply. Once water is taken care of, food is the resource that will run out next. The plants stems naturally feed the flowers with sugars. If you add a bit of sugar (1 tsp.) to the vase water, this will help feed the flower stems and extend their vase life.

Bacteria will build up in vase water and eventually clog up the stem so the flower cannot take up water. To prevent this, change the vase water frequently and make a new cut in the stems every few days.

Floral preservatives, available from florists, contain sugars, acids and bacteriacides that can extend cut flower life. These come in small packets and are generally available where cut flowers are sold. If used properly, these can extend the vase life of some cut flowers 2 to 3 times when compared with just plain water in the vase.

Plant Images