Abies concolor ( Gable's Weeping White Fir )

Characteristics

Cultivar:	Gable's Weeping
Family:	Pinaceae
Size:	Height: 0 ft. to 10 ft. Width: 0 ft. to 0 ft.
Plant Category:	landscape, trees,
Plant Characteristics:	dwarf, low maintenance, prostrate,
Foliage Characteristics:	evergreen,
Foliage Color:	blue-green to gold,
Flower Characteristics:
Flower Color:
Tolerances:	wind,

Requirements

Bloomtime Range:	not applicable
USDA Hardiness Zone:	3 to 7
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Sun to Full Sun
pH Range:	5 to 7
Soil Range:	Mostly Sand to Some Clay
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilization for Young Plants

Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.

How-to : Fertilization for Established Plants

Established plants can benefit from fertilization. Take a visual inventory of your landscape. Trees need to be fertilized every few years. Shrubs and other plants in the landscape can be fertilized yearly. A soil test can determine existing nutrient levels in the soil. If one or more nutrients is low, a specific instead of an all-purpose fertilizer may be required. Fertilizers that are high in N, nitrogen, will promote green leafy growth. Excess nitrogen in the soil can cause excessive vegetative growth on plants at the expense of flower bud development. It is best to avoid fertilizing late in the growing season. Applications made at that time can force lush, vegetative growth that will not have a chance to harden off before the onset of cold weather.

Light

Conditions : Light Conditions

Unless a site is completely exposed, light conditions will change during the day and even during the year. The northern and eastern sides of a house receive the least amount of light, with the northern exposure being the shadiest. The western and southern sides of a house receive the most light and are considered the hottest exposures due to intense afternoon sun.

You will notice that sun and shade patterns change during the day. The western side of a house may even be shady due to shadows cast by large trees or a structure from an adjacent property. If you have just bought a new home or just beginning to garden in your older home, take time to map sun and shade throughout the day. You will get a more accurate feel for your site's true light conditions.

Conditions : Full to Partial Sun

Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!

Conditions : Types of Pruning

Types of pruning include: pinching, thinning, shearing and rejuvenating.

Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.

Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.

Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.

Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.

Conditions : Light and Plant Selection

For best plant performance, it is desirable to match the correct plant with the available light conditions. Right plant, right place! Plants which do not receive sufficient light may become pale in color, have fewer leaves and a "leggy" stretched-out appearance. Also expect plants to grow slower and have fewer blooms when light is less than desirable. It is possible to provide supplemental lighting for indoor plants with lamps. Plants can also receive too much light. If a shade loving plant is exposed to direct sun, it may wilt and/or cause leaves to be sunburned or otherwise damaged.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Planting

How-to : Pruning Trees After Planting

It is critical to prune trees correctly from the beginning to assure proper growth and development. Young trees can be transplanted in a number of forms: bare root, balled & burlap and in containers. The more stress the plant undergoes in the transplant process, the more pruning that is required to compensate.

Deciduous trees like maples (those that loose their leaves in the fall) can be dug up and sold with their bare roots exposed. Because most of the root system is lost in digging, sufficient top growth should be removed to compensate for this loss. This may be done at the nursery before you buy the plant or you may have to prune at the time of planting. Select and head back the best scaffold branches, i.e. those branches which will form the main lateral structure of the future mature tree. Remove all other extraneous side branches. If the tree seedling does not have branches, allow it to grow to the desired height of branching then pinch it back to stimulate the lower buds to form branches.

Ball and burlap trees are dug up with their root systems somewhat intact. This was mostly done for conifers and broadleaf evergreens, but has become common for deciduous trees as well. Since some root mass is lost in the digging stage, a light pruning is generally called for. Head back the plant to compensate for this loss and to promote branching.

Trees that are grown in containers generally do not loose roots in the transplanting phase. Therefore you do not generally have to prune them unless there is some root injury or limb damage in the planting process.

Once you have your trees planted, be patient. Do not remove shoots from the trunk early on as these allow the tree to grow more rapidly and also shade the tender young trunk from sun-scald. Wait a few years to begin training the tree to its ultimate form.

How-to : Planting a Tree

Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.

If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.

If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.

Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.

Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.

Problems

Pest : Aphids

Aphids are small, soft-bodied, slow-moving insects that suck fluids from plants. Aphids come in many colors, ranging from green to brown to black, and they may have wings. They attack a wide range of plant species causing stunting, deformed leaves and buds. They can transmit harmful plant viruses with their piercing/sucking mouthparts. Aphids, generally, are merely a nuisance, since it takes many of them to cause serious plant damage. However aphids do produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface growth called sooty mold.

Aphids can increase quickly in numbers and each female can produce up to 250 live nymphs in the course of a month without mating. Aphids often appear when the environment changes - spring & fall. They're often massed at the tips of branches feeding on succulent tissue. Aphids are attracted to the color yellow and will often hitchhike on yellow clothing.

Prevention and Control: Keep weeds to an absolute minimum, especially around desirable plants. On edibles, wash off infected area of plant. Lady bugs and lacewings will feed on aphids in the garden. There are various products - organic and inorganic - that can be used to control aphids. Seek the recommendation of a professional and follow all label procedures to a tee.

Pest : Caterpillars

Caterpillars are the immature form of moths and butterflies. They are voracious feeders attacking a wide variety of plants. They can be highly destructive and are characterized as leaf feeders, stem borers, leaf rollers, cutworms and tent-formers.

Prevention and Control: keep weeds down, scout individual plants and remove caterpillars, apply labeled insecticides such as soaps and oils, take advantage of natural enemies such as parasitic wasps in the garden and use Bacillus thuringiensis (biological warfare) for some caterpillar species.

Pest : Scale Insects

Scales are insects, related to mealy bugs, that can be a problem on a wide variety of plants - indoor and outdoor. Young scales crawl until they find a good feeding site. The adult females then lose their legs and remain on a spot protected by its hard shell layer. They appear as bumps, often on the lower sides of leaves. They have piercing mouth parts that suck the sap out of plant tissue. Scales can weaken a plant leading to yellow foliage and leaf drop. They also produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface fungal growth called sooty mold.

Prevention and Control: Once established they are hard to control. Isolate infested plants away from those that are not infested. Consult your local garden center professional or Cooperative Extension office in your county for a legal recommendation regarding their control. Encourage natural enemies such as parasitic wasps in the garden.

Miscellaneous

Glossary : Specimen

A specimen can be a tree, shrub, ground cover, annual, or perennial that is unique in comparison to the surrounding plants. Uniqueness may be in color, form, texture, or size. By using only one specimen plant in a visual area, it can be showcased. Specimen plants are accents in the landscape, just as statues, water features, or arbors.

Glossary : Evergreen

Evergreen refers to plants that hold onto their leaves or needles for more than one growing season, shedding them over time. Some plants such as live oaks are evergreen, but commonly shed the majority of their older leaves around the end of January.

Glossary : Tree

Tree: a woody perennial with a crown of branches that begin atop a single stem or trunk. The exception to this rule is multi-trunk trees, which some may argue are really very large shrubs.

Glossary : pH

pH, means the potential of Hydrogen, is the measure of alkalinity or acidity. In horticulture, pH refers to the pH of soil. The scale measures from 0, most acid, to 14, most alkaline. Seven is neutral. Most plants prefer a range between 5.5 and about 6.7, an acid range, but there are plenty of other plants that like soil more alkaline, or above 7. A pH of 7 is where the plant can most easily absorb the most nutrients in the soil. Some plants prefer more or less of certain nutrients, and therefore do better at a certain pH.

Glossary : U. S. Natives

Native plants require lower maintenance and usually have less pest problems. They are key components in the xeriphytic landscape and backyard wildlife habitat. Select your region and the search will look for all plants in the database that are native to your area.

Plant Images