Sorbus thuringiaca ( Turin Mountain Ash )

Characteristics

Cultivar:	n/a
Family:	Rosaceae
Size:	Height: 40 ft. to 50 ft. Width: 20 ft. to 30 ft.
Plant Category:	landscape, trees,
Plant Characteristics:
Foliage Characteristics:	deciduous,
Foliage Color:	dark green,
Flower Characteristics:	showy,
Flower Color:	whites,
Tolerances:	heat & humidity, pollution, slope, wind,

Requirements

Bloomtime Range:	Late Spring to Late Spring
USDA Hardiness Zone:	5 to 8
AHS Heat Zone:	Not defined for this plant
Light Range:	Dappled to Full Sun
pH Range:	4.5 to 7
Soil Range:	Sandy Loam to Some Clay
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilization for Established Plants

Established plants can benefit from fertilization. Take a visual inventory of your landscape. Trees need to be fertilized every few years. Shrubs and other plants in the landscape can be fertilized yearly. A soil test can determine existing nutrient levels in the soil. If one or more nutrients is low, a specific instead of an all-purpose fertilizer may be required. Fertilizers that are high in N, nitrogen, will promote green leafy growth. Excess nitrogen in the soil can cause excessive vegetative growth on plants at the expense of flower bud development. It is best to avoid fertilizing late in the growing season. Applications made at that time can force lush, vegetative growth that will not have a chance to harden off before the onset of cold weather.

Light

Conditions : Dappled Light

Dappled Light refers to a dappled pattern of light created on the ground, as cast by light passing through high tree branches. This is the middle ground, not considered shady, but not sunny either. Dappled remains constant throughout the day.

Conditions : Types of Pruning

Types of pruning include: pinching, thinning, shearing and rejuvenating.

Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.

Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.

Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.

Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Planting

How-to : Pruning Trees After Planting

It is critical to prune trees correctly from the beginning to assure proper growth and development. Young trees can be transplanted in a number of forms: bare root, balled & burlap and in containers. The more stress the plant undergoes in the transplant process, the more pruning that is required to compensate.

Deciduous trees like maples (those that loose their leaves in the fall) can be dug up and sold with their bare roots exposed. Because most of the root system is lost in digging, sufficient top growth should be removed to compensate for this loss. This may be done at the nursery before you buy the plant or you may have to prune at the time of planting. Select and head back the best scaffold branches, i.e. those branches which will form the main lateral structure of the future mature tree. Remove all other extraneous side branches. If the tree seedling does not have branches, allow it to grow to the desired height of branching then pinch it back to stimulate the lower buds to form branches.

Ball and burlap trees are dug up with their root systems somewhat intact. This was mostly done for conifers and broadleaf evergreens, but has become common for deciduous trees as well. Since some root mass is lost in the digging stage, a light pruning is generally called for. Head back the plant to compensate for this loss and to promote branching.

Trees that are grown in containers generally do not loose roots in the transplanting phase. Therefore you do not generally have to prune them unless there is some root injury or limb damage in the planting process.

Once you have your trees planted, be patient. Do not remove shoots from the trunk early on as these allow the tree to grow more rapidly and also shade the tender young trunk from sun-scald. Wait a few years to begin training the tree to its ultimate form.

How-to : Staking Trees

Staking is done differently depending on the size and flexibility of the tree, and the windiness of the planting site. Generally only trees that are planted in windy, exposed locations need to be staked. For most trees, a low stake is preferred, to let the tree move naturally. For windy areas or flexible trees, use a high stake. For trees more than 12 feet tall, use two low stakes on opposite sides of the tree or several guy ropes. The ties used need to accommodate growth and not cause bark damage with friction. Buckle-and-spacer ties can be found at garden centers, they are expandable and have a protective spacer. Ties without spacers should be formed into a figure eight to create padding. Latest studies have shown that when staking a tree, provide enough leeway so that the tree can move back and forth in the wind. Stronger roots will develop this way. If the tree can not move back and forth, these important roots will not develop and the tree might fall over during a storm, once stakes are removed. When planting a tree, stake at the time of planting if staking is a necessity.

How-to : Planting a Tree

Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.

If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.

If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.

Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.

Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.

Problems

Pest : Sawfly Larvae

Sawflies look similar to wasps, but do not have stingers or waists. Sawflies were named for the way the females ""sawed"" openings into hosts, where eggs were laid. The larvae of the sawfly is the actual villain, causing damage to fruit or foliage as it matures. The small, green larvae of the sawflies are caterpillar-like or slug-like in appearance.

Prevention and Control: No prevention available. Control by handpicking or spraying with a recommended insecticide. Birds, beetles and viruses usually keep the sawfly under control.

Pest : Aphids

Aphids are small, soft-bodied, slow-moving insects that suck fluids from plants. Aphids come in many colors, ranging from green to brown to black, and they may have wings. They attack a wide range of plant species causing stunting, deformed leaves and buds. They can transmit harmful plant viruses with their piercing/sucking mouthparts. Aphids, generally, are merely a nuisance, since it takes many of them to cause serious plant damage. However aphids do produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface growth called sooty mold.

Aphids can increase quickly in numbers and each female can produce up to 250 live nymphs in the course of a month without mating. Aphids often appear when the environment changes - spring & fall. They're often massed at the tips of branches feeding on succulent tissue. Aphids are attracted to the color yellow and will often hitchhike on yellow clothing.

Prevention and Control: Keep weeds to an absolute minimum, especially around desirable plants. On edibles, wash off infected area of plant. Lady bugs and lacewings will feed on aphids in the garden. There are various products - organic and inorganic - that can be used to control aphids. Seek the recommendation of a professional and follow all label procedures to a tee.

Fungi : Powdery Mildew

Powdery Mildew is usually found on plants that do not have enough air circulation or adequate light. Problems are worse where nights are cool and days are warm and humid. The powdery white or gray fungus is usually found on the upper surface of leaves or fruit. Leaves will often turn yellow or brown, curl up, and drop off. New foliage emerges crinkled and distorted. Fruit will be dwarfed and often drops early.

Prevention and Control: Plant resistant varieties and space plants properly so they receive adequate light and air circulation. Always water from below, keeping water off the foliage. This is paramount for roses. Go easy on the nitrogen fertilizer. Apply fungicides according to label directions before problem becomes severe and follow directions exactly, not missing any required treatments. Sanitation is a must - clean up and remove all leaves, flowers, or debris in the fall and destroy.

Diseases : Anthracnose

Anthracnose is the result of a plant infection, caused by a fungus, and may cause severe defoliation, especially in trees, but rarely results in death. Sunken patches on stems, fruit, leaves, or twigs, appear grayish brown, may appear watery, and have pinkish-tan spore masses that appear slime-like. On vegetables, spots may enlarge as fruit matures.

Prevention and Control: Try not to over water. If your climate is naturally rainy, grow resistant varieties. In the vegetable garden, stake and trellis plants to provide good air circulation so that plants may dry. Increase sunlight to plants by trimming limbs. Prune, remove, or destroy infected plants and remove all leaf debris. Select a fungicide that is labeled for anthracnose and the plant you are treating. Follow the label strictly.

Pest : Scale Insects

Scales are insects, related to mealy bugs, that can be a problem on a wide variety of plants - indoor and outdoor. Young scales crawl until they find a good feeding site. The adult females then lose their legs and remain on a spot protected by its hard shell layer. They appear as bumps, often on the lower sides of leaves. They have piercing mouth parts that suck the sap out of plant tissue. Scales can weaken a plant leading to yellow foliage and leaf drop. They also produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface fungal growth called sooty mold.

Prevention and Control: Once established they are hard to control. Isolate infested plants away from those that are not infested. Consult your local garden center professional or Cooperative Extension office in your county for a legal recommendation regarding their control. Encourage natural enemies such as parasitic wasps in the garden.

Diseases : Blight

Blights are cause by fungi or bacteria that kill plant tissue. Symptoms often show up as the rapid spotting or wilting of foliage. There are many different blights, specific to various plants, each requiring a varied method of control.

Miscellaneous

Conditions : Slope Tolerant

Slope tolerant plants are those that have a fibrous root system and are often plants that prefer good soil drainage. These plants assist in erosion control by stabilizing/holding the soil on slopes intact.

Conditions : Wind Tolerant

Plants that are wind tolerant usually have flexible, strong branches that are not brittle. Wind tolerant plants often have thick or waxy leaves that control moisture loss from whipping winds. Native plants are often the best adapted to not only wind, but also soil and other climatic conditions.

Conditions : Fall Color

Fall color is the result of trees or shrubs changing colors according to complex chemical formulas present in their leaves. Depending on how much iron, magnesium, phosphorus, or sodium is in the plant, and the acidity of the chemicals in the leaves, leaves might turn amber, gold, red, orange or just fade from green to brown. Scarlet oaks, red maples and sumacs, for instance, have a slightly acidic sap, which causes the leaves to turn bright red. The leaves of some varieties of ash, growing in areas where limestone is present, will turn a regal purplish-blue.

Although many people believe that cooler temperatures are responsible for the color change, the weather has nothing to do with it at all. As the days grow shorter and the nights longer, a chemical clock inside the trees starts up, releasing a hormone which restricts the flow of sap to each leaf. As fall progresses, the sap flow slows and chlorophyll, the chemical that gives the leaves their green color in the spring and summer, disappears. The residual sap becomes more concentrated as it dries, creating the colors of fall.

Glossary : Deciduous

Deciduous refers to those plants that lose their leaves or needles at the end of the growing season.

Glossary : Large Tree

A tree is considered large when it is over 30 feet tall.

Plant Images