Stenocarpus sinuatus ( Firewheel Tree )

Characteristics

Cultivar:	n/a
Family:	Proteaceae
Size:	Height: 70 ft. to 100 ft. Width: 15 ft. to 50 ft.
Plant Category:	trees,
Plant Characteristics:	columnar,
Foliage Characteristics:	evergreen,
Foliage Color:	dark green,
Flower Characteristics:	showy, unusual,
Flower Color:	reds,
Tolerances:	deer,

Requirements

Bloomtime Range:	Mid Summer to Late Summer
USDA Hardiness Zone:	10 to 11
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Sun to Full Sun
pH Range:	5.5 to 6.5
Soil Range:	Sandy Loam to Clay Loam
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilization for Young Plants

Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.

How-to : Fertilization for Established Plants

Established plants can benefit from fertilization. Take a visual inventory of your landscape. Trees need to be fertilized every few years. Shrubs and other plants in the landscape can be fertilized yearly. A soil test can determine existing nutrient levels in the soil. If one or more nutrients is low, a specific instead of an all-purpose fertilizer may be required. Fertilizers that are high in N, nitrogen, will promote green leafy growth. Excess nitrogen in the soil can cause excessive vegetative growth on plants at the expense of flower bud development. It is best to avoid fertilizing late in the growing season. Applications made at that time can force lush, vegetative growth that will not have a chance to harden off before the onset of cold weather.

Light

Conditions : Full to Partial Sun

Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!

Conditions : Types of Pruning

Types of pruning include: pinching, thinning, shearing and rejuvenating.

Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.

Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.

Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.

Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

Problems : Creating a Water Ring

A water ring, sometimes called a water well, is a mound of compacted soil that is built around the circumference of a planting hole once a plant has been installed. The water ring helps to direct water to the outer edges of a planting hole, encouraging new roots to grow outward, in search of moisture. The height of the mound of soil will vary from a couple of inches for 3 gallon shrubs, to almost a foot for balled and burlapped trees, especially those planted on a slope. Mulch over the ring will help to further conserve moisture and prevent deterioration of the ring itself. Once a plant is established, the water ring may be leveled, but you should continue to mulch beneath the plant.

Problems : Waterlogged Soil and Solutions

Waterlogged soil occurs when more water is added to soil than can drain out in a reasonable amount of time. This can be a severe problem where water tables are high or soils are compacted. Lack of air space in waterlogged soil makes it almost impossible for soil to drain. Few plants, except for bog plants, can tolerate these conditions. Drainage must be improved if you are not satisfied with bog gardening. Over-watered plants have the same wilted leaves as under-watered plants. Fungi such as Phytophthora and Pythium affect vascular systems, which cause wilt.

If the problem is only on the surface, it maybe diverted to a drainage ditch. If drainage is poor where water table is high, install an underground drainage system. You should contact a contractor for this. If underground drains already exist, check to see if they are blocked.

French drains are another option. French drains are ditches that have been filled with gravel. It is okay to plant sod on top of them. More obtrusive, but a good solution where looks aren't as important, think of the French drain as a ditch filled with gravel. Ditches should be 3 to 4 feet deep and have sloping sides.

A soakway is a gravel filled pit where water is diverted to via underground pipes. This works well on sites that have compacted soil. Your soakway should be about 6'wide and deep and filled with gravel or crushed stone, topped with sand and sodded or seeded.

Keep in mind that it is illegal to divert water onto other people's property. If you do not feel that you can implement a workable solution on your own, call a contractor.

Tools : Watering Aides

No gardener depends 100% on natural rainfall. Even the most water conscious garden appreciates the proper hose, watering can or wand.

Watering Cans: Whether you choose plastic of galvanized makes no difference, but do look for generous capacity and a design that is balanced when filled with water. A 2 gallon can (which holds 18 lbs. of water) is preferred by most gardeners and is best suited for outdoor use. Indoor cans should be relatively smaller with narrower spouts and roses (the filter head).

Watering Hose: When purchasing a hose, look for one that is double-walled, as it will resist kinking. Quick coupler links are nice to have on ends of hoses to make altering length fast. To extend the life of your hose, keep it wound around a reel and stored in a shady area. Prior to winter freezes, drain hose.

Sprayers: Are commonly thought of as devices for applying chemicals, but can really be a step saver for watering houseplants or small pots of annuals rather that dragging out a hose or making numerous trips with a watering can. The backpack sprayer is best suited for this. Take care not to use any kind of chemical in tanks used for watering!

Sprinklers: Attached to the ends of garden hoses, these act as an economical irrigation system. Standing Spike Sprinklers are usually intended for lawns and deliver water in a circular pattern. Rotating Sprinklers deliver a circle of water and are perfect for lawns, shrubs and flower beds. Pulse-jet sprinklers cover large areas of ground in a pulsating, circular pattern. The head usually sits up on a tall stem, except for when watering lawns. Oscillating sprinklers are best for watering at ground level in a rectangular pattern.

Conditions : Regular Moisture for Outdoor Plants

Water when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not to overwater. The first two years after a plant is installed, regular watering is important. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Conditions : Outdoor Watering

Plants are almost completely made up of water so it is important to supply them with adequate water to maintain good plant health. Not enough water and roots will wither and the plant will wilt and die. Too much water applied too frequently deprives roots of oxygen leading to plant diseases such as root and stem rots. The type of plant, plant age, light level, soil type and container size all will impact when a plant needs to be watered. Follow these tips to ensure successful watering:

* The key to watering is water deeply and less frequently. When watering, water well, i.e. provide enough water to thoroughly saturate the root ball. With in-ground plants, this means thoroughly soaking the soil until water has penetrated to a depth of 6 to 7 inches (1' being better). With container grown plants, apply enough water to allow water to flow through the drainage holes.

* Try to water plants early in the day or later in the afternoon to conserve water and cut down on plant stress. Do water early enough so that water has had a chance to dry from plant leaves prior to night fall. This is paramount if you have had fungus problems.

* Don't wait to water until plants wilt. Although some plants will recover from this, all plants will die if they wilt too much (when they reach the permanent wilting point).

* Consider water conservation methods such as drip irrigation, mulching, and xeriscaping. Drip systems which slowly drip moisture directly on the root system can be purchased at your local home and garden center. Mulches can significantly cool the root zone and conserve moisture.

* Consider adding water-saving gels to the root zone which will hold a reserve of water for the plant. These can make a world of difference especially under stressful conditions. Be certain to follow label directions for their use.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

How-to : Reduce Watering

This plant requires less watering during winter months, so reduce watering from late November through early March.

Planting

How-to : Pruning Trees After Planting

It is critical to prune trees correctly from the beginning to assure proper growth and development. Young trees can be transplanted in a number of forms: bare root, balled & burlap and in containers. The more stress the plant undergoes in the transplant process, the more pruning that is required to compensate.

Deciduous trees like maples (those that loose their leaves in the fall) can be dug up and sold with their bare roots exposed. Because most of the root system is lost in digging, sufficient top growth should be removed to compensate for this loss. This may be done at the nursery before you buy the plant or you may have to prune at the time of planting. Select and head back the best scaffold branches, i.e. those branches which will form the main lateral structure of the future mature tree. Remove all other extraneous side branches. If the tree seedling does not have branches, allow it to grow to the desired height of branching then pinch it back to stimulate the lower buds to form branches.

Ball and burlap trees are dug up with their root systems somewhat intact. This was mostly done for conifers and broadleaf evergreens, but has become common for deciduous trees as well. Since some root mass is lost in the digging stage, a light pruning is generally called for. Head back the plant to compensate for this loss and to promote branching.

Trees that are grown in containers generally do not loose roots in the transplanting phase. Therefore you do not generally have to prune them unless there is some root injury or limb damage in the planting process.

Once you have your trees planted, be patient. Do not remove shoots from the trunk early on as these allow the tree to grow more rapidly and also shade the tender young trunk from sun-scald. Wait a few years to begin training the tree to its ultimate form.

How-to : Staking Trees

Staking is done differently depending on the size and flexibility of the tree, and the windiness of the planting site. Generally only trees that are planted in windy, exposed locations need to be staked. For most trees, a low stake is preferred, to let the tree move naturally. For windy areas or flexible trees, use a high stake. For trees more than 12 feet tall, use two low stakes on opposite sides of the tree or several guy ropes. The ties used need to accommodate growth and not cause bark damage with friction. Buckle-and-spacer ties can be found at garden centers, they are expandable and have a protective spacer. Ties without spacers should be formed into a figure eight to create padding. Latest studies have shown that when staking a tree, provide enough leeway so that the tree can move back and forth in the wind. Stronger roots will develop this way. If the tree can not move back and forth, these important roots will not develop and the tree might fall over during a storm, once stakes are removed. When planting a tree, stake at the time of planting if staking is a necessity.

How-to : Planting a Tree

Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.

If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.

If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.

Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.

Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.

Problems

Miscellaneous

Glossary : Sandy Loam

Sandy Loam refers to a soil that drains well, with excellent air space, and evenly crumbled texture when squeezed in the hand. A good workable garden soil that benefits from added fertilizer and proper watering. Dark gray to gray-brown in color.

Glossary : Clayey Loam

Clayey loam refers to a soil that retains moisture well, without having a drainage problem. Fertility is high and texture good. Easily forms a ball when squeezed in the hand, and then crumbles easily with a quick tap of the finger. Considered an ideal soil. Usually a rich brown color.

Glossary : Evergreen

Evergreen refers to plants that hold onto their leaves or needles for more than one growing season, shedding them over time. Some plants such as live oaks are evergreen, but commonly shed the majority of their older leaves around the end of January.

Glossary : Pruning

Now is the preferred time to prune this plant.

Plant Images