Papaver rhoeas ( Reverend Wilks Corn Poppy )

Characteristics

Cultivar:	Reverend Wilks
Family:	Papaveraceae
Size:	Height: 0 ft. to 3 ft. Width: 0 ft. to 1 ft.
Plant Category:	annuals and biennials,
Plant Characteristics:	low maintenance, seed start,
Foliage Characteristics:	medium leaves,
Foliage Color:	green,
Flower Characteristics:	long lasting, showy,
Flower Color:	pinks, reds, whites,
Tolerances:	pollution, rabbits, slope, wind,

Requirements

Bloomtime Range:	Early Summer to Late Summer
USDA Hardiness Zone:	2 to 10
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Sun to Full Sun
pH Range:	5 to 8
Soil Range:	Some Sand to Some Clay
Water Range:	Normal to Moist

Plant Care

Fertilizing

How-to : Fertilization for Annuals and Perennials

Annuals and perennials may be fertilized using: 1.water-soluble, quick release fertilizers; 2. temperature controlled slow-release fertilizers; or 3. organic fertilizers such as fish emulsion. Water soluble fertilizers are generally used every two weeks during the growing season or per label instructions. Controlled, slow-release fertilizers are worked into the soil ususally only once during the growing season or per label directions. For organic fertilizers such as fish emulsion, follow label directions as they may vary per product.

Light

Conditions : Full to Partial Sun

Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!

Watering

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Planting

How-to : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

How-to : Planting and Removing Annuals

When planting annuals, begin by preparing the soil. Rototill rotted compost, soil conditioner, pulverized bark, or even builders sand into the existing soil and rake it smooth. Annuals grow quickly, so space them as recommended on plant tags. Remove plants from their containers or packs gently, being sure to keep as much soil as you can around the root ball. If the rootball is tight, loosen it a bit by gently separating white, matted roots with your fingers or a pocket knife. Plant at the same depth they were in the containers. Gently fill in around the plants, providing support but not cutting off air to the roots. Water the plants well.

Through the season, be sure to fertilize for optimal performance. Take special care to cut back or completely remove any diseased plants, as soon as you see there is a problem. At the end of the season, be sure to remove all plants and their root balls. Rake the bed well to prepare it for the next season's planting.

How-to : Pinching and Thinning Perennials

Once you plant a perennial, it does not mean that you will enjoy years of maintenance-free gardening. Perennials need to be cared for just like any other plant. One thing that distinguishes perennials is that they tend to be active growers that have to be thinned out occasionally or they will loose vigor.

As perennials establish, it is important to prune them back and thin them out occasionally. This will prevent them from completely taking over an area to the exclusion of other plants, and also will increase air circulation thereby reducing the incidence of diseases like botrytis and powdery mildew.

Many species also flower abundantly and produce ample seed. As blooms fade it is advisable to deadhead your plant; that is, to remove spent flowers before they form seed. This will prevent your plants from seeding all over the garden and will conserve the considerable energy it takes the plant to produce seed.

As perennials mature, they may form a dense root mass that eventually leads to a less vigorous plant. It is advisable to occasionally thin out a stand of such perennials. By dividing the root system, you can make new plants to plant in another area of the garden or give away. Also root pruning will stimulate new growth and rejuvenate the plant. Most perennials may be successfully divided in either spring or fall. Do a little homework; some perennials do have a preference.

How-to : Preparing Containers

Containers are excellent when used as an ornamental feature, a planting option when there is little or no soil to plant in, or for plants that require a soil type not found in the garden or when soil drainage in the garden is inferior. If growing more than one plant in a container, make sure that all have similar cultural requirements. Choose a container that is deep and large enough to allow root development and growth as well as proportional balance between the fully developed plant and the container. Plant large containers in the place you intend them to stay. All containers should have drainage holes. A mesh screen, broken clay pot pieces(crock) or a paper coffee filter placed over the hole will keep soil from washing out. The potting soil you select should be an appropriate mix for the plants you have chosen. Quality soils (or soil-less medias) absorb moisture readily and evenly when wet. If water runs off soil upon initial wetting, this is an indicator that your soil may not be as good as you think.

Prior to filling a container with soil, wet potting soil in the bag or place in a tub or wheelbarrow so that it is evenly moist. Fill container about halfway full or to a level that will allow plants, when planted, to be just below the rim of the pot. Rootballs should be level with soil line when project is complete. Water well.

Problems

Miscellaneous

Conditions : Rabbit Tolerant

As cute as they are, rabbits can really damage a vegetable garden. Young, tender lettuce plants seem to be their favorite. If a free-roaming dog is not a possibility for you, consider installing raised vegetable beds and covering tender shoots with netting. If you have ample room, you can opt to plant enough for you and the bunnies. Scents don't always repel animals, as they get used to them and are often washed off in the rain.

Conditions : Salt Tolerant

Anyone that lives close to the coast or in areas where soil salt content is high, can appreciate a plant that is salt tolerant. Salt damage is usually worse where the climate is arid: there is not enough rainfall to wash built up salts from the soil. It takes about 30 inches of rainfall a year to move salt through the soil. Plants that have salt damage usually have yellow leaves, brown tips or margins, and leaf drop. Soils may have a crusty white layer, too. Salt tolerant plants are often natives or introduced plants that have evolved in salty conditions.

Conditions : Slope Tolerant

Slope tolerant plants are those that have a fibrous root system and are often plants that prefer good soil drainage. These plants assist in erosion control by stabilizing/holding the soil on slopes intact.

Conditions : Wind Tolerant

Plants that are wind tolerant usually have flexible, strong branches that are not brittle. Wind tolerant plants often have thick or waxy leaves that control moisture loss from whipping winds. Native plants are often the best adapted to not only wind, but also soil and other climatic conditions.

Glossary : Low Maintenance

Low maintenance does not mean no maintenance. It does mean that once a plant is established, very little needs to be done in the way of water, fertilizing, pruning, or treatment in order for the plant to remain healthy and attractive. A well-designed garden, which takes your lifestyle into consideration, can greatly reduce maintenance.

Glossary : Naturalizing

Naturalizing refers to planting in a random pattern, much as itwould occur in nature. If you spend any time in the woods, you've probably noticed that plants often grow in groups. The center of the group is dense and towards the edges, plants are located farther apart. Narcissus bulbs are easy to naturalize if you use this method: fill a bucket with bulbs and toss them out. Plant them where they fall. You will notice a portion of the bulbs are close together while the others have scattered farther away.

Glossary : Annual

An annual is any plant that completes its life cycle in one growing season.

Glossary : Seed Start

Seed Start: easily propagated from seed.

Glossary : pH

pH, means the potential of Hydrogen, is the measure of alkalinity or acidity. In horticulture, pH refers to the pH of soil. The scale measures from 0, most acid, to 14, most alkaline. Seven is neutral. Most plants prefer a range between 5.5 and about 6.7, an acid range, but there are plenty of other plants that like soil more alkaline, or above 7. A pH of 7 is where the plant can most easily absorb the most nutrients in the soil. Some plants prefer more or less of certain nutrients, and therefore do better at a certain pH.

How-to : Getting the Most Out of Cut Flowers

Cut flowers bring the garden into your home. While some cut flowers have a long vase life, most are highly perishable. How cut flowers are treated when you first bring them home can significantly increase how long they last.

The most important thing to consider is getting sufficient water taken up into the cut stem. Insufficient water can result in wilting and short-lived flowers. Bent neck of roses, where the flower head droops, is the result of poor water uptake. To maximize water uptake, first re-cut the stems at an angle so that the vascular system (the ""plumbing"" of the stem) is clear. Next immerse the cut stems in warm water.

Remember when the flower is cut, it is cut off from its food supply. Once water is taken care of, food is the resource that will run out next. The plants stems naturally feed the flowers with sugars. If you add a bit of sugar (1 tsp.) to the vase water, this will help feed the flower stems and extend their vase life.

Bacteria will build up in vase water and eventually clog up the stem so the flower cannot take up water. To prevent this, change the vase water frequently and make a new cut in the stems every few days.

Floral preservatives, available from florists, contain sugars, acids and bacteriacides that can extend cut flower life. These come in small packets and are generally available where cut flowers are sold. If used properly, these can extend the vase life of some cut flowers 2 to 3 times when compared with just plain water in the vase.

Plant Images