Bambusa balcooa ( Bamboo )

Characteristics

Cultivar:	n/a
Family:	Poaceae
Size:	Height: 60 ft. to 60 ft. Width: 0 ft. to 0 ft.
Plant Category:	ornamental grasses and bamboos,
Plant Characteristics:	columnar, low maintenance, spreading,
Foliage Characteristics:	evergreen,
Foliage Color:	green,
Flower Characteristics:
Flower Color:
Tolerances:	heat & humidity,

Requirements

Bloomtime Range:	not applicable
USDA Hardiness Zone:	8 to 11
AHS Heat Zone:	Not defined for this plant
Light Range:	Part Shade to Full Sun
pH Range:	5.5 to 6.5
Soil Range:	Sandy Loam to Clay Loam
Water Range:	Normal to Moist

Plant Care

Fertilizing

Light

Conditions : Partial Shade

Partial Shade is defined as filtered light found beneath trees with high limbs. Partial shade usually offers some protection from direct afternoon sun.

Conditions : Dappled Light

Dappled Light refers to a dappled pattern of light created on the ground, as cast by light passing through high tree branches. This is the middle ground, not considered shady, but not sunny either. Dappled remains constant throughout the day.

Conditions : Part Sun

Part Sun refers to filtered light, with most sun being received during the afternoon hours. Shade usually occurs during the morning hours.

Conditions : Light Conditions

Unless a site is completely exposed, light conditions will change during the day and even during the year. The northern and eastern sides of a house receive the least amount of light, with the northern exposure being the shadiest. The western and southern sides of a house receive the most light and are considered the hottest exposures due to intense afternoon sun.

You will notice that sun and shade patterns change during the day. The western side of a house may even be shady due to shadows cast by large trees or a structure from an adjacent property. If you have just bought a new home or just beginning to garden in your older home, take time to map sun and shade throughout the day. You will get a more accurate feel for your site's true light conditions.

Conditions : Filtered Light

For many plants that prefer partially shady conditions, filtered light is ideal. Good planting sites are under a mid to large sized tree that lets some light through their branches or beneath taller plants that will provide some protection.

Conditions : Partial Sun, Partial Shade

Part sun or part shade plants prefer light that is filtered. Sunlight, though not direct, is important to them. Often morning sun, because it is not as strong as afternoon sun, can be considered part sun or part shade. If you live in an area that does not get much intense sun, such as the Pacific Northwest, a full sun exposure may be fine. In other areas such as Florida, plant in a location where afternoon shade will be received.

Conditions : Full to Partial Sun

Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!

Conditions : Types of Pruning

Types of pruning include: pinching, thinning, shearing and rejuvenating.

Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.

Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.

Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.

Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.

Conditions : Light and Plant Selection

For best plant performance, it is desirable to match the correct plant with the available light conditions. Right plant, right place! Plants which do not receive sufficient light may become pale in color, have fewer leaves and a "leggy" stretched-out appearance. Also expect plants to grow slower and have fewer blooms when light is less than desirable. It is possible to provide supplemental lighting for indoor plants with lamps. Plants can also receive too much light. If a shade loving plant is exposed to direct sun, it may wilt and/or cause leaves to be sunburned or otherwise damaged.

Conditions : Full Sun

Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.

Watering

How-to : Xeriscaping

Xeriscaping is a method of planting which promotes naturally drought tolerant plants and water saving methods. Much consideration is given not only to the plants chosen for the design, but the design itself. Lawns are greatly decreased in size and usually located in the center of plantings at a lower grade as to catch any runoff. Shrubs requiring the most water, are conservatively used and thoughtfully placed, where they may be easily watered, preferably from runoff, and moisture conserved. There is a strong emphasis on using native plants, which a purist will do exclusively. At the very least, improved cultivars of natives are highly recommended.

Irrigation maybe used to supplement watering, but takes a creative turn in the form of drip systems and recycled catch water. Organic mulches in the form of compost, straws, and barks are also used to retain as much water as possible. In extremely dry areas, it is not uncommon for gravel and rocks to serve as the mulch.

A xeriphytic landscape is one that takes your particular site into consideration. A plant that maybe considered low water usage in one area of the country, may not be in another area, due to climatic stresses.

Conditions : Moist

Moist is defined as soil that receives regular watering to a depth of 18 inch deep, does not dry out, but does not have a drainage problem either.

Conditions : Regular Moisture for Outdoor Plants

Water when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not to overwater. The first two years after a plant is installed, regular watering is important. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Conditions : Moist and Well Drained

Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.

Conditions : Outdoor Watering

Plants are almost completely made up of water so it is important to supply them with adequate water to maintain good plant health. Not enough water and roots will wither and the plant will wilt and die. Too much water applied too frequently deprives roots of oxygen leading to plant diseases such as root and stem rots. The type of plant, plant age, light level, soil type and container size all will impact when a plant needs to be watered. Follow these tips to ensure successful watering:

* The key to watering is water deeply and less frequently. When watering, water well, i.e. provide enough water to thoroughly saturate the root ball. With in-ground plants, this means thoroughly soaking the soil until water has penetrated to a depth of 6 to 7 inches (1' being better). With container grown plants, apply enough water to allow water to flow through the drainage holes.

* Try to water plants early in the day or later in the afternoon to conserve water and cut down on plant stress. Do water early enough so that water has had a chance to dry from plant leaves prior to night fall. This is paramount if you have had fungus problems.

* Don't wait to water until plants wilt. Although some plants will recover from this, all plants will die if they wilt too much (when they reach the permanent wilting point).

* Consider water conservation methods such as drip irrigation, mulching, and xeriscaping. Drip systems which slowly drip moisture directly on the root system can be purchased at your local home and garden center. Mulches can significantly cool the root zone and conserve moisture.

* Consider adding water-saving gels to the root zone which will hold a reserve of water for the plant. These can make a world of difference especially under stressful conditions. Be certain to follow label directions for their use.

Conditions : Normal Watering for Outdoor Plants

Normal watering means that soil should be kept evenly moist and watered regularly, as conditions require. Most plants like 1 inch of water a week during the growing season, but take care not to over water. The first two years after a plant is installed, regular watering is important for establishment. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.

Planting

How-to : Preparing Garden Beds

Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.

A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.

Problems

Fungi : Rusts

Most rusts are host specific and overwinter on leaves, stems and spent flower debris. Rust often appears as small, bright orange, yellow, or brown pustules on the underside of leaves. If touched, it will leave a colored spot of spores on the finger. Caused by fungi and spread by splashing water or rain, rust is worse when weather is moist.

Prevention and Control: Plant resistant varieties and provide maximum air circulation. Clean up all debris, especially around plants that have had a problem. Do not water from overhead and water only during the day so that plants will have enough time to dry before night. Apply a fungicide labeled for rust on your plant.

Fungi : Leaf Spots

Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.

Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.

Weeds : Preventing Weeds and Grass

Weeds rob your plants of water, nutrients and light. They can harbor pests and diseases. Before planting, remove weeds either by hand or by spraying an herbicide according to label directions. Another alternative is to lay plastic over the area for a couple of months to kill grass and weeds.

You may apply a pre-emergent herbicide prior to planting, but be sure that it is labeled for the plants you are wishing to grow. Existing beds may be spot sprayed with a nonselective herbicide, but be careful to shield those plants you do not want to kill. Non-selective means that it will kill everything it comes in contact with.

Mulch plants with a 3 inch layer of pinestraw, pulverized bark, or compost. Mulch conserves moisture, keeps weeds down, and makes it easier to pull when necessary.

Porous landscape or open weave fabric works too, allowing air and water to be exchanged.

Pest : Slugs and Snails

Begin looking for slugs and snails so that you may set traps.

Weeds : Bamboo

Bamboo is a great plant, as long as you're happy it is in your garden. But, if you find nothing appealing about this plant and it has taken hold in your garden, you may feel helpless when it comes to getting rid of it. Bamboos spread by underground stems called rhizomes. The following bamboos are known for sending out long rhizomes from which a new shoot, or plant, may arise: Phyllostachys, Pleioblastus, and Sasa. These canes will live for several years prior to turning brown. Clumping bamboos are usually not a problem.

Prevention and Control: There are several methods to rid yourself of bamboo. If time is on your side and you are patient, you may cut back all canes to the ground and repeat the cutting process, never allowing new canes to reach over 2 feet tall. Eventually, the roots will starve and you will be able to dig them out.

If you need faster results, a combination of chemical treatment and pruning will work best. Begin by cutting the bamboo canes almost back to the ground. Then make a vertical chop into the top of each cane with an ax. Paint the stumps with a recommended product. Make sure you wear protective clothing and rubber gloves to do this. Within a few weeks the bamboo should be dead and you can dig it out. You may have to repeat this process on really stubborn shoots.

Miscellaneous

Conditions : Erosion Control

Plants that help to control erosion have fibrous root systems that help to keep soil intact. Leaves and the overall form of a plant can prevent erosion by breaking up water droplets before they hit the ground, lessening splashing and runoff.

Glossary : Low Maintenance

Low maintenance does not mean no maintenance. It does mean that once a plant is established, very little needs to be done in the way of water, fertilizing, pruning, or treatment in order for the plant to remain healthy and attractive. A well-designed garden, which takes your lifestyle into consideration, can greatly reduce maintenance.

Glossary : Specimen

A specimen can be a tree, shrub, ground cover, annual, or perennial that is unique in comparison to the surrounding plants. Uniqueness may be in color, form, texture, or size. By using only one specimen plant in a visual area, it can be showcased. Specimen plants are accents in the landscape, just as statues, water features, or arbors.

Glossary : Evergreen

Evergreen refers to plants that hold onto their leaves or needles for more than one growing season, shedding them over time. Some plants such as live oaks are evergreen, but commonly shed the majority of their older leaves around the end of January.

Glossary : pH

pH, means the potential of Hydrogen, is the measure of alkalinity or acidity. In horticulture, pH refers to the pH of soil. The scale measures from 0, most acid, to 14, most alkaline. Seven is neutral. Most plants prefer a range between 5.5 and about 6.7, an acid range, but there are plenty of other plants that like soil more alkaline, or above 7. A pH of 7 is where the plant can most easily absorb the most nutrients in the soil. Some plants prefer more or less of certain nutrients, and therefore do better at a certain pH.

Glossary : Tolerant

Tolerant refers to a plant's ability to tolerate exposure to an external condition(s). It does not mean that the plant thrives or prefers this situation, but is able to adapt and continue its life cycle.

Plant Images