Cytisus covers a range of deciduous, semi-evergreen and evergreen shrubs. All are members of the legume family and have the characteistic pea-shaped flowers, many are quite fragrant. Extremely hardy plants that tolerate wind, seashore, and infertile soil. Keep pruned after flowering to reduce seedpod production. Will sow itself quite freely. 'Golden Sunlight' is a flowering, deciduous shrub that produces arching branches and fan-like leaves. Abundant flowers of pale gold bloom in May and June.
Important Info : Some species such as C.scoparius have become very invasive in certain regions, efforts have been made to remove them.
Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.
Conditions : Full Sun
Full Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.
Conditions : Regular Moisture for Outdoor Plants
Water when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not
to overwater. The first two years after a plant is installed, regular watering
is important. The first year is critical. It is better to water once a week
and water deeply, than to water frequently for a few minutes.
How-to : Pruning Flowering Shrubs
It is necessary to prune your deciduous flowering shrub for two reasons:
1. By removing old, damaged or dead wood, you increase air flow, yielding in less disease. 2. You rejuvenate new growth which increases flower production.
Pruning deciduous shrubs can be divided into 4 groups: Those that
require minimal pruning (take out only dead, diseased, damaged, or
crossed branches, can be done in early spring.); spring pruning
(encourages vigorous, new growth which produces summer flowers - in other words,
flowers appear on new wood); summer pruning after flower (after
flowering, cut back shoots, and take out some of the old growth, down to the
ground); suckering habit pruning (flowers appear on wood from previous
year. Cut back flowered stems by 1/2, to strong growing new shoots and remove
1/2 of the flowered stems a couple of inches from the ground) Always remove dead, damaged or diseased wood first, no matter what type of pruning you are doing.
Dig a hole twice the size of the root ball and deep enough to plant at the
same level the shrub was in the container. If soil is poor, dig hole even wider
and fill with a mixture half original soil and half compost or soil
Carefully remove shrub from container and gently separate roots. Position in center of hole, best side facing forward. Fill in with original soil or an amended mixture if needed as described above. For larger shrubs, build a water well. Finish by mulching and watering well.
If the plant is balled-and-burlapped, remove fasteners and fold back the top of natural burlap, tucking it down into hole, after you've positioned shrub. Make sure that all burlap is buried so that it won't wick water away from rootball during hot, dry periods. If synthetic burlap, remove if possible. If not possible, cut away or make slits to allow for roots to develop into the new soil. For larger shrubs, build a water well.
Finish by mulching and watering well.
If shrub is bare-root, look for a discoloration somewhere near the base; this mark is likely where the soil line was. If soil is too sandy or too clayey, add organic matter. This will help with both drainage and water holding capacity. Fill soil, firming just enough to support shrub. Finish by mulching and watering well.
How-to : Preparing Containers
Containers are excellent when used as an ornamental feature, a planting option when there is little or no soil to plant in, or for plants that require a soil type not found in the garden or when soil drainage in the garden is inferior. If growing more than one plant in a container, make sure that all have similar cultural requirements. Choose a container that is deep and large enough to allow root development and growth as well as proportional balance between the fully developed plant and the container. Plant large containers in the place you intend them to stay. All containers should have drainage holes. A mesh screen, broken clay pot pieces(crock) or a paper coffee filter placed over the hole will keep soil from washing out. The potting soil you select should be an appropriate mix for the plants you have chosen. Quality soils (or soil-less medias) absorb moisture readily and evenly when wet. If water runs off soil upon initial wetting, this is an indicator that your soil may not be as good as you think.
Prior to filling a container with soil, wet potting soil in the bag or place in a tub or wheelbarrow so that it is evenly moist. Fill container about halfway full or to a level that will allow plants, when planted, to be just below the rim of the pot. Rootballs should be level with soil line when project is complete. Water well.
Conditions : Salt Tolerant
Anyone that lives close to the coast or in areas where soil salt content is high, can appreciate a plant that is salt tolerant. Salt damage is usually worse where the climate is arid: there is not enough rainfall to wash
built up salts from the soil. It takes about 30 inches of rainfall a year to move salt through the soil. Plants that have salt damage usually have yellow leaves, brown tips or margins, and leaf drop. Soils may have a crusty white layer, too. Salt tolerant plants are often natives or introduced plants that have evolved in salty conditions.
Conditions : Wind Tolerant
Plants that are wind tolerant usually have flexible, strong branches that are not brittle. Wind tolerant plants often have thick or waxy leaves that
control moisture loss from whipping winds. Native plants are often the best adapted to not only wind, but also soil and other climatic conditions.