Parkinsonia aculeata is a small to medium growing deciduos tree or shrub, 15 to 30 feet tall, and as wide. The bark is yellow-green, branches have spiny twigs, a very open, sparse growth pattern. Yellow flowers on 3 to 7 inch clusters in spring, sporadically the rest of the year. It is a fast grower initially, then slows down, best to stake the young plant and train for high or low branch pattern. Once established it is low maintenance, but best kept out of manicured areas, hard surfaces due to leaf and twig litter. A drought tolerant plant, tolerant of dry, alkaline soils.
Google Plant Images: click here!
Characteristics
Cultivar: n/aFamily: Fabaceae
Size: Height: 15 ft. to 30 ft.
Width: 15 ft. to 20 ft.
Plant Category: shrubs, trees,
Plant Characteristics: weeping,
Foliage Characteristics: deciduous,
Flower Characteristics: fragrant,
Flower Color: yellows,
Tolerances: deer, drought, pollution, rabbits, slope, wind,
Requirements
Bloomtime Range: Early Spring to Late Spring
USDA Hardiness Zone: 7 to 9
AHS Heat Zone: Not defined for this plant
Light Range: Sun to Full Sun
pH Range: 5.5 to 9
Soil Range: Mostly Sand to Clay Loam
Water Range: Semi-Arid to Normal
Plant Care
Fertilizing
How-to : Fertilization for Young PlantsYoung plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.
Light
Conditions : Full SunFull Sun is defined as exposure to more than 6 hours of continuous, direct sun per day.
Watering
Conditions : Regular Moisture for Outdoor PlantsWater when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not to overwater. The first two years after a plant is installed, regular watering is important. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.
Planting
How-to : Planting ShrubsDig a hole twice the size of the root ball and deep enough to plant at the same level the shrub was in the container. If soil is poor, dig hole even wider and fill with a mixture half original soil and half compost or soil amendment.
Carefully remove shrub from container and gently separate roots. Position in center of hole, best side facing forward. Fill in with original soil or an amended mixture if needed as described above. For larger shrubs, build a water well. Finish by mulching and watering well.
If the plant is balled-and-burlapped, remove fasteners and fold back the top of natural burlap, tucking it down into hole, after you've positioned shrub. Make sure that all burlap is buried so that it won't wick water away from rootball during hot, dry periods. If synthetic burlap, remove if possible. If not possible, cut away or make slits to allow for roots to develop into the new soil. For larger shrubs, build a water well. Finish by mulching and watering well.
If shrub is bare-root, look for a discoloration somewhere near the base; this mark is likely where the soil line was. If soil is too sandy or too clayey, add organic matter. This will help with both drainage and water holding capacity. Fill soil, firming just enough to support shrub. Finish by mulching and watering well.
How-to : Staking Trees
Staking is done differently depending on the size and flexibility of the tree, and the windiness of the planting site. Generally only trees that are planted in windy, exposed locations need to be staked. For most trees, a low stake is preferred, to let the tree move naturally. For windy areas or flexible trees, use a high stake. For trees more than 12 feet tall, use two low stakes on opposite sides of the tree or several guy ropes. The ties used need to accommodate growth and not cause bark damage with friction. Buckle-and-spacer ties can be found at garden centers, they are expandable and have a protective spacer. Ties without spacers should be formed into a figure eight to create padding. Latest studies have shown that when staking a tree, provide enough leeway so that the tree can move back and forth in the wind. Stronger roots will develop this way. If the tree can not move back and forth, these important roots will not develop and the tree might fall over during a storm, once stakes are removed. When planting a tree, stake at the time of planting if staking is a necessity.
How-to : Planting a Tree
Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.
If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.
If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.
Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.
Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.
Problems
Pest : Spider MitesSpider mites are small, 8 legged, spider-like creatures which thrive in hot, dry conditions (like heated houses). Spider mites feed with piercing mouth parts, which cause plants to appear yellow and stippled. Leaf drop and plant death can occur with heavy infestations. Spider mites can multiply quickly, as a female can lay up to 200 eggs in a life span of 30 days. They also produce a web which can cover infested leaves and flowers.
Prevention and Control: Keep weeds down and remove infested plants. Dry air seems to worsen the problem, so make sure plants are regularly watered, especially those preferring high humidity such as tropicals, citrus, or tomatoes. Always check new plants prior to bringing them home from the garden center or nursery. Take advantage of natural enemies such as ladybug larvae. If a miticide is recommended by your local garden center professional or county Cooperative Extension office, read and follow all label directions. Concentrate your efforts on the undersides of the leaves as that is where spider mites generally live.
Fungi : Leaf Spots
Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.
Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.
Miscellaneous
Glossary : Low MaintenanceLow maintenance does not mean no maintenance. It does mean that once a plant is established, very little needs to be done in the way of water, fertilizing, pruning, or treatment in order for the plant to remain healthy and attractive. A well-designed garden, which takes your lifestyle into consideration, can greatly reduce maintenance.
Glossary : U. S. Natives
Native plants require lower maintenance and usually have less pest problems. They are key components in the xeriphytic landscape and backyard wildlife habitat. Select your region and the search will look for all plants in the database that are native to your area.
Glossary : Drought Tolerant
Very few plants, except for those naturally found in desert situations, can tolerate arid soils, but there are plants that seem to be more drought tolerant than others. Plants that are drought tolerant still require moisture, so don't think that they can go for extended period without any water. Drought tolerant plants are often deep rooted, have waxy or thick leaves that conserve water, or leaf structures that close to minimize transpiration. All plants in droughty situations benefit from an occasional deep watering and a 2-3 inch thick layer of mulch. Drought tolerant plants are the backbone of xeriphytic landscaping.