Parthenocissus tricuspidata is a deciduous vine, native to China and Japan. In milder areas it behaves as a semi-evergreen. Extremely vigorous, outpacing even Virginia Creeper. The glossy 8 inch leaves are divided into 3 lobes or leaflets, in fall they turn a lovely burgundy, sometimes orange. Grows very densely, forming a uniform covering over buildings, screens. ‘Veitchii’ bears dark red-purple leaves in the fall.
Google Plant Images: click here!
Characteristics
Cultivar: VeitchiiFamily: Vitaceae
Size: Height: 0 ft. to 70 ft.
Width: 0 ft. to 0 ft.
Plant Category: climbers, landscape,
Plant Characteristics:
Foliage Characteristics: deciduous,
Flower Characteristics:
Flower Color: greens,
Tolerances: deer, drought, heat & humidity, pollution, rabbits, seashore, slope, wind,
Requirements
Bloomtime Range: Early Summer to Early Summer
USDA Hardiness Zone: 4 to 8
AHS Heat Zone: Not defined for this plant
Light Range: Shade to Sun
pH Range: 4.5 to 8
Soil Range: Some Sand to Some Clay
Water Range: Dry to Moist
Plant Care
Fertilizing
How-to : Fertilization for Young Plants Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.
Light
Conditions : Full to Partial Shade Full shade means there is little or no light in the growing zone. Shade can be the result of a mature stand of trees or shadows cast by a house or building. Plants that require full shade are usually susceptible to sunburn. Full shade beneath trees may pose additional problems; not only is there no light, but competition for water, nutrients and root space.
Partial shade means that an area receives filtered light, often through tall branches of an open growing tree. Root competition is usually less. Partial shade can also be achieved by locating a plant beneath an arbor or lathe-like structure. Shadier sides of a building are normally the northern or northeastern sides. These sides also tend to be a little cooler. It is not uncommon for plants that can tolerate full sun or some sun in cooler climates to require some shade in warmer climates due to stress placed on the plant from reduced moisture and excessive heat.
Conditions : Partial Sun, Partial Shade
Part sun or part shade plants prefer light that is filtered. Sunlight, though not direct, is important to them. Often morning sun, because it is not as strong as afternoon sun, can be considered part sun or part shade. If you live in an area that does not get much intense sun, such as the Pacific Northwest, a full sun exposure may be fine. In other areas such as Florida, plant in a location where afternoon shade will be received.
Conditions : Full to Partial Sun
Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!
Conditions : Types of Pruning
Types of pruning include: pinching, thinning, shearing and rejuvenating.
Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.
Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.
Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.
Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.
Watering
Conditions : Regular Moisture for Outdoor Plants Water when normal rainfall does not provide the preferred 1 inch of moisture most plants prefer. Average water is needed during the growing season, but take care not to overwater. The first two years after a plant is installed, regular watering is important. The first year is critical. It is better to water once a week and water deeply, than to water frequently for a few minutes.
Planting
How-to : Planting Vines & Climbers Choose the planting site for your climber carefully: its long flexible stems may need some shelter, but planting right next to a wall might keep it from the sun or water it needs. Make sure that there's room for the climber to grow when it gets tall, and remember that it will grow towards the sun unless carefully trained. Be sure you will be able to manage the plant once it becomes tall, or that if it has a mind of its own, it won't become a problem.
Select a support structure before you plant your climber. Common support structures are trellises, wires, strings, or existing structures. Some plants, like ivy, climb by aerial roots and need no support. Aerial rooted climbers are fine for concrete and masonary, but should never be allowed to climb on wood. Clematis climbs by leaf stalks and the Passion flower by coiling tendrils. Akebia and Wisteria climb by twining stems in a spiral fashion around its support.
Do not use permanent ties; the plant will quickly outgrow them. Use soft, flexible ties (twist-ties work well), or even strips of pantyhose, and check them every few months. Make sure that your support structure is strong, rust-proof, and will last the life of the plant. Anchor your support structure before you plant your climber.
Dig a hole large enough for the root ball. Plant the climber at the same level it was in the container. Plant a little deeper for clematis or for grafted plants. Fill the hole with soil, firming as you, and water well. As soon as the stems are long enough to reach their support structure, gently and loosely tie them as necessary.
If planting in a container, follow the same guidelines. Plan ahead by adding a trellis to the pot, especially if the container will not be positioned where a support for the vine is not readily available. It is possible for vines and climbers to ramble on the ground or cascade over walls too. Clematis and Roses actually work quite well this way.
How-to : Preparing Garden Beds
Use a soil testing kit to determine the acidity or alkalinity of the soil before beginning any garden bed preparation. This will help you determine which plants are best suited for your site. Check soil drainage and correct drainage where standing water remains. Clear weeds and debris from planting areas and continue to remove weeds as soon as they come up.
A week to 10 days before planting, add 2 to 4 inches of aged manure or compost and work into the planting site to improve fertility and increase water retention and drainage. If soil composition is weak, a layer of topsoil should be considered as well. No matter if your soil is sand or clay, it can be improved by adding the same thing: organic matter. The more, the better; work deep into the soil. Prepare beds to an 18 inch deep for perennials. This will seem like a tremendous amount of work now, but will greatly pay off later. Besides, this is not something that is easily done later, once plants have been established.
Problems
Fungi : Powdery Mildew Powdery Mildew is usually found on plants that do not have enough air circulation or adequate light. Problems are worse where nights are cool and days are warm and humid. The powdery white or gray fungus is usually found on the upper surface of leaves or fruit. Leaves will often turn yellow or brown, curl up, and drop off. New foliage emerges crinkled and distorted. Fruit will be dwarfed and often drops early.
Prevention and Control: Plant resistant varieties and space plants properly so they receive adequate light and air circulation. Always water from below, keeping water off the foliage. This is paramount for roses. Go easy on the nitrogen fertilizer. Apply fungicides according to label directions before problem becomes severe and follow directions exactly, not missing any required treatments. Sanitation is a must - clean up and remove all leaves, flowers, or debris in the fall and destroy.
Fungi : Leaf Spots
Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.
Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.
Pest : Scale Insects
Scales are insects, related to mealy bugs, that can be a problem on a wide variety of plants - indoor and outdoor. Young scales crawl until they find a good feeding site. The adult females then lose their legs and remain on a spot protected by its hard shell layer. They appear as bumps, often on the lower sides of leaves. They have piercing mouth parts that suck the sap out of plant tissue. Scales can weaken a plant leading to yellow foliage and leaf drop. They also produce a sweet substance called honeydew (coveted by ants) which can lead to an unattractive black surface fungal growth called sooty mold.
Prevention and Control: Once established they are hard to control. Isolate infested plants away from those that are not infested. Consult your local garden center professional or Cooperative Extension office in your county for a legal recommendation regarding their control. Encourage natural enemies such as parasitic wasps in the garden.
Fungi : Downy Mildew
Downy Mildew, a fluffy white fungal growth that develops on the underside of leaves, is most common during cool, humid conditions. Foliage often discolors and is stunted.
Prevention and Control: Use disease free plants and space far enough apart so that air circulation is good. Remove and discard infected leaves or even entire plants. Use a recommended fungicide and always follow the directions on the label.
Miscellaneous
Conditions : Pollution TolerantAir pollution is becoming a bigger problem each day. Pollutants in our air damage plants. The plants are damaged by absorbing sulfur dioxide, ozone, peroxyacetyl nitrate, ethylene, and nitrogen dioxide through their pores. Cell membrane damage may result in leaf drop, blotched or burnt looking leaves, or off-colored tissue between veins. Vehicles and industrial processes are the key culprits and conditions worsen on hot summer days. Though planting only pollution tolerant plants is not the solution to this problem, it is a visual band aid. Your Cooperative Extension Service may have a list of plants that are more pollution tolerant in your area.
Conditions : Salt Tolerant
Anyone that lives close to the coast or in areas where soil salt content is high, can appreciate a plant that is salt tolerant. Salt damage is usually worse where the climate is arid: there is not enough rainfall to wash built up salts from the soil. It takes about 30 inches of rainfall a year to move salt through the soil. Plants that have salt damage usually have yellow leaves, brown tips or margins, and leaf drop. Soils may have a crusty white layer, too. Salt tolerant plants are often natives or introduced plants that have evolved in salty conditions.
Conditions : Slope Tolerant
Slope tolerant plants are those that have a fibrous root system and are often plants that prefer good soil drainage. These plants assist in erosion control by stabilizing/holding the soil on slopes intact.
Glossary : Bird Attracting
The term bird attracting applies to any plant that has flowers, fruit, nuts, or structure that attracts birds. Most plants on ""bird attracting"" lists have favorable fruits or flowers that serve as food, but the trunks, limbs and foliage cover that trees and shrubs provide should not be overlooked as they add shelter for raising young and protection from foul weather.
Glossary : Deciduous
Deciduous refers to those plants that lose their leaves or needles at the end of the growing season.
Glossary : Semi-Evergreen
Semi-Evergreen: a plant that retains some or most of its foliage throughout the year.
Glossary : Drought Tolerant
Very few plants, except for those naturally found in desert situations, can tolerate arid soils, but there are plants that seem to be more drought tolerant than others. Plants that are drought tolerant still require moisture, so don't think that they can go for extended period without any water. Drought tolerant plants are often deep rooted, have waxy or thick leaves that conserve water, or leaf structures that close to minimize transpiration. All plants in droughty situations benefit from an occasional deep watering and a 2-3 inch thick layer of mulch. Drought tolerant plants are the backbone of xeriphytic landscaping.