The Acanthophoenix is a single trunk, spear-pinnate shaped palm. The cylindrical crown shaft is vivid green. This palm has red veins displayed on deep green fronds that fade with age. Sharp spines are prominent in youth and most shed as they age. The leaflets are green or white bottomed and pendulous. Grows well from almost sea-level to relatively high elavations. This genus has become rare due to the over-harvesting of the cabbages.
Google Plant Images: click here!
Size: Height: 0 ft. to 60 ft.
Width: 12 ft. to 20 ft.
Plant Category: palms and cycads,
Plant Characteristics: seed start,
Foliage Characteristics: coarse leaves, evergreen,
Flower Color: pinks, purples, reds, whites, yellows,
Tolerances: heat & humidity, wind,
Bloomtime Range: Mid Summer to Mid Summer
USDA Hardiness Zone: 9 to 11
AHS Heat Zone: Not defined for this plant
Light Range: Full Sun to Full Sun
pH Range: Not defined for this plant
Soil Range: Sand to Loam
Water Range: Normal to Normal
FertilizingHow-to : Fertilization for Young Plants
Young plants need extra phosphorus to encourage good root development. Look for a fertilizer that has phosphorus, P, in it(the second number on the bag.) Apply recommended amount for plant per label directions in the soil at time of planting or at least during the first growing season.
How-to : Fertilization for Established Plants
Established plants can benefit from fertilization. Take a visual inventory of your landscape. Trees need to be fertilized every few years. Shrubs and other plants in the landscape can be fertilized yearly. A soil test can determine existing nutrient levels in the soil. If one or more nutrients is low, a specific instead of an all-purpose fertilizer may be required. Fertilizers that are high in N, nitrogen, will promote green leafy growth. Excess nitrogen in the soil can cause excessive vegetative growth on plants at the expense of flower bud development. It is best to avoid fertilizing late in the growing season. Applications made at that time can force lush, vegetative growth that will not have a chance to harden off before the onset of cold weather.
How-to : Fertilizing Houseplants
Houseplants may be fertilized with: 1. water-soluble, quick release fertilizers; 2. temperature controlled slow-release fertilizers; 3. or organic fertilizers such as fish emulsion. Water soluble fertilizers are used every two weeks or per label instructions. Controlled, slow-release fertilizers are carefully worked into the soil usually only once during the growing season or per label directions. For organic fertilizers, such as fish emulsion, follow label directions. Allow houseplants to 'rest' during the winter months; stop fertilizing in late October and resume feeding in late February.
How-to : Fertilize Monthly
Now is the time to begin fertilizing with a water-soluble fertilizer. Continue through the end of summer.
LightConditions : Moderate Light for Houseplants
Place houseplants that require moderate light within 5 feet of an eastern or western exposure window.
Conditions : Moisture-loving Houseplants
Houseplants that require ample water, or those labeled as moisture-loving houseplants require that they be watered thoroughly until the soil is saturated and then drains freely from holes in the bottom of pot. Re-water when potting soil becomes dry to the touch an inch or so below the soil surface.
Conditions : Full to Partial Sun
Full sunlight is needed for many plants to assume their full potential. Many of these plants will do fine with a little less sunlight, although they may not flower as heavily or their foliage as vibrant. Areas on the southern and western sides of buildings usually are the sunniest. The only exception is when houses or buildings are so close together, shadows are cast from neighboring properties. Full sun usually means 6 or more hours of direct unobstructed sunlight on a sunny day. Partial sun receives less than 6 hours of sun, but more than 3 hours. Plants able to take full sun in some climates may only be able to tolerate part sun in other climates. Know the culture of the plant before you buy and plant it!
Conditions : Types of Pruning
Types of pruning include: pinching, thinning, shearing and rejuvenating.
Pinching is removing the stem tips of a young plant to promote branching. Doing this avoids the need for more severe pruning later on.
Thinning involves removing whole branches back to the trunk. This may be done to open up the interior of a plant to let more light in and to increase air circulation that can cut down on plant disease. The best way to begin thinning is to begin by removing dead or diseased wood.
Shearing is leveling the surface of a shrub using hand or electric shears. This is done to maintain the desired shape of a hedge or topiary.
Rejuvenating is removal of old branches or the overall reduction of the size of a shrub to restore its original form and size. It is recommended that you do not remove more than one third of a plant at a time. Remember to remove branches from the inside of the plant as well as the outside. When rejuvenating plants with canes, such as nandina, cut back canes at various heights so that plant will have a more natural look.
WateringConditions : Moist and Well Drained
Moist and well drained means exactly what it sounds like. Soil is moist without being soggy because the texture of the soil allows excess moisture to drain away. Most plants like about 1 inch of water per week. Amending your soil with compost will help improve texture and water holding or draining capacity. A 3 inch layer of mulch will help to maintain soil moisture and studies have shown that mulched plants grow faster than non-mulched plants.
PlantingHow-to : Potting Indoor Plants
Make sure that the plant you have chosen is suitable for the conditions you are able to provide it: that it will have enough light, space, and a temperature it will like. Remember that the area right next to a window will be colder than the rest of the room.
Indoor plants need to be transplanted into a larger container periodically, or they become pot/root-bound and their growth is retarded. Water the plant well before starting, so the soil will hold the root ball together when you remove it from the pot. If you have trouble getting the plant out of the pot, try running a blade around the edge of the pot, and gently whacking the sides to loosen the soil.
Always use fresh soil when transplanting your indoor plant. Fill around the plant gently with soil, being careful not to pack too tightly -- you want air to be able to get to the roots. After the plant is in the new pot, don't fertilize right away... this will encourage the roots to fill in their new home.
The size pot you choose is important too. Select one that is not more than about 1 inch greater in diameter. Remember, many plants prefer being somewhat pot bound. Always start with a clean pot!
How-to : Planting a Tree
Dig out an area for the tree that is about 3 or 4 times the diameter of the container or rootball and the same depth as the container or rootball. Use a pitchfork or shovel to scarify the sides of the hole.
If container-grown, lay the tree on its side and remove the container. Loosen the roots around the edges without breaking up the root ball too much. Position tree in center of hole so that the best side faces forward. You are ready to begin filling in with soil.
If planting a balled and burlaped tree, position it in hole so that the best side faces forward. Untie or remove nails from burlap at top of ball and pull burlap back, so it does not stick out of hole when soil is replaced. Synthetic burlap should be removed as it will not decompose like natural burlap. Larger trees often come in wire baskets. Plant as you would a b&b plant, but cut as much of the wire away as possible without actually removing the basket. Chances are, you would do more damage to the rootball by removing the basket. Simply cut away wires to leave several large openings for roots.
Fill both holes with soil the same way. Never amend with less than half original soil. Recent studies show that if your soil is loose enough, you are better off adding little or no soil amendments.
Create a water ring around the outer edge of the hole. Not only will this conseve water, but will direct moisture to perimeter roots, encouraging outer growth. Once tree is established, water ring may be leveled. Studies show that mulched trees grow faster than those unmulched, so add a 3"" layer of pinestraw, compost, or pulverized bark over backfilled area. Remove any damaged limbs.
ProblemsPest : Spider Mites
Spider mites are small, 8 legged, spider-like creatures which thrive in hot, dry conditions (like heated houses). Spider mites feed with piercing mouth parts, which cause plants to appear yellow and stippled. Leaf drop and plant death can occur with heavy infestations. Spider mites can multiply quickly, as a female can lay up to 200 eggs in a life span of 30 days. They also produce a web which can cover infested leaves and flowers.
Prevention and Control: Keep weeds down and remove infested plants. Dry air seems to worsen the problem, so make sure plants are regularly watered, especially those preferring high humidity such as tropicals, citrus, or tomatoes. Always check new plants prior to bringing them home from the garden center or nursery. Take advantage of natural enemies such as ladybug larvae. If a miticide is recommended by your local garden center professional or county Cooperative Extension office, read and follow all label directions. Concentrate your efforts on the undersides of the leaves as that is where spider mites generally live.
Fungi : Leaf Spots
Leaf spots are caused by fungi or bacteria. Brown or black spots and patches may be either ragged or circular, with a water soaked or yellow-edged appearance. Insects, rain, dirty garden tools, or even people can help its spread.
Prevention and Control: Remove infected leaves when the plant is dry. Leaves that collect around the base of the plant should be raked up and disposed of. Avoid overhead irrigation if possible; water should be directed at soil level. For fungal leaf spots, use a recommended fungicide according to label directions.
MiscellaneousGlossary : Container Plant
A plant that is considered to be a good container plant is one that does not have a tap root, but rather a more confined, fibrous root system. Plants that usually thrive in containers are slow- growing or relatively small in size. Plants are more adaptable than people give them credit for. Even large growing plants can be used in containers when they are very young, transplanted to the ground when older. Many woody ornamentals make wonderful container plants as well as annuals, perennials, vegetables, herbs, and bulbs.
Glossary : Sandy Loam
Sandy Loam refers to a soil that drains well, with excellent air space, and evenly crumbled texture when squeezed in the hand. A good workable garden soil that benefits from added fertilizer and proper watering. Dark gray to gray-brown in color.
Glossary : Evergreen
Evergreen refers to plants that hold onto their leaves or needles for more than one growing season, shedding them over time. Some plants such as live oaks are evergreen, but commonly shed the majority of their older leaves around the end of January.
Glossary : Perennial
Perennial: traditionally a non-woody plant that lives for two or more growing seasons.
Glossary : Seed Start
Seed Start: easily propagated from seed.
Glossary : Foliage Characteristics
By searching foliage characteristics, you will have the opportunity to look for foliage with distinguishable features such as variegated leaves, aromatic foliage, or unusual texture, color or shape. This field will be most helpful to you if you are looking for accent plants. If you have no preference, leave this field blank to return a larger selection of plants.
Glossary : Landscape Uses
By searching Landscape Uses, you will be able to pinpoint plants that are best suited for particular uses such as trellises, border plantings, or foundations.